Advertisement
Installation Guidelines
Follow these guidelines when installing the TVS:
•
When connecting the TVS to an INPUT/OUTPUT port on an AMX
device, the Yellow (signal) wire is connected to the I/O pin on the
INPUT/OUTPUT port.
•
Do not over-torque screws on the connector. Doing so can damage
the seating pin and damage the connector.
•
If your application includes multiple CRT's in close proximity, use
MED or LOW sensitivity settings to minimize potential interference.
•
Mount the TVS close to the picture tube yoke. In most cases, the pic-
ture tube yoke is located in the rear center of the CRT cabinet. Be
sure to place the TVS in a position where the green LED signal indi-
cator is visible during installation.
Advertisement
