Installing The Water Line - Samsung RS25H5121 Series User Manual

CHECKING THE WATER
DISPENSER LINE
A water dispenser is one of the helpful features on
your new Samsung Refrigerator.
To help promote better health, the Samsung water
filter removes unwanted particles from your water.
However, it does not sterilize or destroy
microorganisms.
You may need to purchase a water purifying
system to do that.
In order for the ice maker to operate properly, a
water pressure of 20~125 psi (pound per square
inch) is required.
Under normal conditions, a 170 cc (5.75 oz.) paper
cup can be filled in 10 seconds.
If the Refrigerator is installed in an area with low
water pressure (below 20psi), you can install a
booster pump to compensate for the low pressure.
Make sure the water storage tank inside the
Refrigerator is properly filled.
To do this, press the water dispenser lever until the
water runs from the water outlet.
Water line installation kits are available at
extra cost from your dealer.
We recommend using a water supply kit
that contains copper tubing.
Connecting to the water supply line
1. First, shut off the main water supply line and
turn the ice-maker off.
2. Locate the nearest cold, drinking water line.
3. After connecting the water supply to the water
filter, turn your main water supply back on and
flush 3 gallons (Flush approximately 6 minutes)
into a bucket to clear and prime the water filter.
Cold water line
Pipe clamp
Shut off valve
SSEDA-14 (RS25H5121) .indd 16

INSTALLING THE WATER LINE

Connecting the water line to the
Refrigerator.
There are several items that you need to purchase
to complete this connection.
You may find these items sold as a kit at your local
hardware store.
• 1/4" compression nut
• copper tubing
1. Tighten the compression nut ( B ) into the 1/4"
- If you are using copper tubing, slip the
- If you are using plastic tubing ( B ), insert the
Water line installation kit
Do not use without the molded end (Bulb) of the
plastic tubing ( B ).
English - 16
Refrigerator
Compression Nut
(1/4") (Assembled)
Ferrule
(Not supplied)
Copper tubing Plastic tubing (B)
or
(Not supplied) (Not supplied)
Household water line
compression fitting.
compression nut ( B ) (not included) and ferrule
(not included) on copper tubing (not included)
as shown.
molded end (Bulb) of the plastic tubing ( B ) into
the compression fitting.
CAUTION
• plastic tubing
• ferrule
Plastic Tubing
(Supplied)
Compression Fitting
(Assembled)
Bulb (B)
Compression
nut (B) (1/4")
(Not supplied)
2013. 11. 28. 11:28