Delta CL180 Instruction Manual page 9

Depending on room temperature, line
voltage, and existing charge level, ini-
tial battery charging may take longer
than one hour.
Disconnect charger from power
source when not in use.
Special Charge Modes: If all lights
go out after the battery is inserted,
the charger has entered pre-charge
mode. In approximately 5-10 min-
utes, the orange and red lights should
turn on indicating that fast charge has
been initiated. If all lights remain off
after 15 minutes, remove the battery.
The orange light should glow.
Reinsert the battery. If the orange
light goes out when the battery is
inserted and all lights remain off for
15 minutes, battery should be
replaced.
After inserting battery, if the orange
light is on while the red and green
lights remain off, remove battery and
re-insert. If the orange light is on while
the red and green lights remain off,
battery should be replaced.
INSTALLING OR REMOVING
BATTERY PACK
TO REMOVE
Depress the battery release button
(B) Fig. 7, and pull battery pack out of
tool.
TO INSTALL BATTERY PACK: Align
rails (A) Fig. 7, on the tool with the
four tabs on the battery pack, and
push battery pack onto tool until it
locks in place.
HOW TO HOLD THE
DRILL/DRIVER
The front end of the
Drill/Driver may be made live if the tool
drills into live wiring in the wall. TO
PREVENT ACCIDENTAL ELECTRICAL
SHOCK, DRILL/DRIVER MUST BE
HELD AS SHOWN IN FIG. 8.
GENERAL DRILLING
1. Set torque adjusting collar for
drilling operation and set speed
selector to appropriate speed.
2. Be sure drill bit is securely
gripped in chuck.
BATTERY PACK:
D
C
D
A
B
9
B
A
C
D
Fig. 5
D
Fig. 6
Fig. 7
Fig. 8