SAVE THESE INSTRUCTIONS Definitions: Safety Guidelines 1) WORK AREA SAFETY The definitions below describe the level of severity for each a) Keep work area clean and well lit. Cluttered or dark areas invite accidents. signal word. Please read the manual and pay attention to these b) Do not operate power tools in explosive atmospheres, such as in the symbols.
protection used for appropriate conditions will reduce personal injuries. f) Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. c) Prevent unintentional starting. Ensure the switch is in the off position before plugging in.
• Young children and the infirm. This appliance is not intended for use by • Do not operate this tool for long periods of time. Vibration caused by tool action young children or infirm persons without supervision. Young children should be may be harmful to your hands and arms.
• DO NOT splash or immerse in water or other liquids. CAUTION: When not in use, place tool on its side on a stable surface where it • Do not store or use the tool and battery pack in locations where the will not cause a tripping or falling hazard.
Important Safety Instructions for All Battery Chargers • Do not place any object on top of charger or place the charger on a soft surface that might block the ventilation slots and result in excessive internal SAVE THESE INSTRUCTIONS: This manual contains important safety and operating heat.
Charging Procedure (Fig. 1) WEAK BATTERY PACKS: Weak batteries will continue to function but should not be expected to perform as much work. 1. Plug the charger into an appropriate outlet before inserting battery pack. FAULTY BATTERY PACKS: This charger will not charge a faulty battery pack. The 2.
DO NOT use under wet conditions or in presence of flammable liquids or gases. I. Belt hook screw This impact wrench/driver is a professional power tool. DO NOT let children come into J. Anvil (DCF813-XE) contact with the tool. Supervision is required when inexperienced operators use this tool.
ASSEMBLY AND ADJUSTMENTS FIG. 3 WARNING: To reduce the risk of serious personal injury, place the forward/ reverse button in the lock-off position or turn tool off and disconnect battery pack before making any adjustments or removing/installing attachments or accessories. Belt Hook (Optional Accessory) To remove the battery pack from the tool, press the release button (G) and firmly pull WARNING: To reduce the risk of serious personal injury, place the forward/...
Page 11
Your impact tool generates the following output torque: Place the forward/reverse button (B) in the locked off (center) position or remove Cat # Ft.-Lbs. In.-Lbs. battery pack before changing accessories. DCF813-XE 1150 FIG. 4 FIG. 5 DCF815-XE CAUTION: Ensure fastener and/or system will withstand the level of torque generated by the tool.
MAINTENANCE Recommended accessories for use with your tool are available at extra cost from your local service center. If you need any assistance in locating any accessory, please WARNING: To reduce the risk of serious personal injury, place the forward/ contact Stanley Black &...