Hitachi C 12FSA Instruction Manual And Safety Instructions page 21

(3) Setting to cut crown moldings at positions q and r in Fig. 28 (see Fig. 33; tilt the head to the right):
q Turn the turntable to the right and set the Miter Angle as follows:
* For 45°type crown moldings: 35.3° ( mark)
* For 38°type crown moldings: 31.6° ( mark)
w Tilt the head to the right and set the Bevel Angle as follows:
* For 45°type crown moldings: 30° ( mark)
* For 38°type crown moldings: 33.9° ( mark)
e Position the crown molding so that the upper surface (B in Fig. 27) contacts the fence as indicated
Fig. 34.
(4) Setting to cut crown moldings at positions w and e in Fig. 28 (see Fig. 33; tilt the head to the right):
q Turn the turntable to the left and set the Miter Angle as follows:
* For 45°type crown moldings: 35.3° ( mark)
* For 38°type crown moldings: 31.6° ( mark)
w Tilt the head to the right and set the Bevel Angle as follows:
* For 45°type crown moldings: 30° ( mark)
* For 38°type crown moldings: 33.9° ( mark)
e Position the crown molding so that the lower surface (A in Fig. 27) contacts the fence as in Fig. 36.
Head
r
Miter Angle
Scale
Fence
B
11. Groove cutting procedures
Grooves in the workpiece can be cut as indicated in Fig. 37 by adjusting the 8mm depth adjustment bolt.
Bevel Angle Scale
q
Fence
Base
Turntable
Fig. 33
A
Table on Base
Fig. 34
Cut grooves with saw blade
a
b
Fig. 37
Head
e
Fence
Miter Angle
Turntable
Scale
Fig. 35
Fence
A
Table on Base
Fig. 36
8mm Depth Adjustment Bolt
8mm Wing Nut
b
Bottom Line of
the Groove
Fig. 38
English
Bevel Angle Scale
w
Base
B
Hinge
Turntable
21