Power Wheels Instructions Manual page 8

4
Black
Cover Lid
• Count up three rings from the
bottom of the flexible tube. Fit the
notch in the black cover lid around
the tube near the third ring.
5
Flexible
Tube
• Lower the black cover lid onto
the black cover bottom and press
into place.
• Insert the screws into the black
cover lid and tighten with a Phillips
screwdriver. Do not over-tighten.
Super 6 and 12 Volt Vehicles
Flexible
Tube
Third
Ring
• Pull on the flexible tube to
make sure it is secured inside
the black cover. If the tube
slides away from the black
cover, remove the screws and
black cover lid and repeat steps
3 through 5.
Conversion of the H-Style Wire
Harness Converter is complete.
See battery charging instruc-
tions on pages 9, 10, 12, 14 and
15. If you've purchased extra
batteries and need additional
black cover lids, bottoms,
flexible tubes or screws, please
call Power Wheels
Affairs at 1-800-348-0751.
8
® Consumer