Precautions In Sales Promotion; Safety Instructions - Hitachi WF 4V Service Manual

Automatic screw driver

Hide thumbs Also See for WF 4V:

Table of Contents

7. PRECAUTIONS IN SALES PROMOTION

In the interest of promoting the safest and most efficient use of model WF 4V by all our customers, it is very

important that at the time of sales the salesperson carefully ensures that the buyer seriously recognizes the

importance of the contents of the Handling Instructions, and fully understands the meaning of the precautions

listed on the Caution Plate and Nameplate attached to each tool.

A. Handling Instructions

Although every effort is made in each step of design, manufacture and inspection to provide protection against

any hazards, the dangers inherent in the use of any electric power tool cannot be completely eliminated.

Accordingly, general precautions and suggestions for the use of electric power tools, and specific precautions and

suggestions for the use of the electric screwdriver are listed in the Handling Instructions to enhance the safe,

efficient use of the tool by the customer. Salespersons must be thoroughly familiar with the contents of the

Handling Instructions to be able to offer appropriate guidance to the customer during sales promotion.

B. Nameplate

Each tool is provided with a Nameplate which lists the following basic safety precautions in the use of the tool:

(1) For Europe (except Germany), Australia and New Zealand

CAUTION

Read thoroughly HANDLING INSTRUCTIONS before use.

(2) For Germany

ACHTUNG

Bedienungsanleitung vor Inbetriebnahme lesen.

7-2. Precautions in Sales Promotion

Ensure that the following precautions are taken for sales promotion of this unit.

7-2-1. Precautions When Using the Main Body

(1) Use the specified genuine bit.

Using any bit other than the one specifically designed for the automatic screwdriver WF 4V may lead to

incompletely tightened or improperly fed screws, so ensure that your customers do not use any bit other than

that specified.

(2) Do not lubricate the main unit.

Ensure that the main unit is never lubricated because this may lead to improper operation or other troubles. If

the slider section is lubricated, if first moves smoothly but plasterboard powder gradually sticks to the oil,

making the slider movement sluggish. Ensure that the plasterboard powder deposited around the slider is

frequently cleaned away with compressed air before the slider movement becomes slow.

--- 7 ---

Table of Contents