Healthrider HRTL14508.0 User Manual page 12

If you purchase the optional chest pulse sensor (see page 26), follow the steps below to install the re-
ceiver included with the chest pulse sensor.
1. Make sure that the power cord is unplugged.
Remove the indicated #8 x 1/2" Screw (17) from
the Pulse Receiver Cover (95) on the back of the
console assembly.
2. Next, hold the receiver so that the antenna is
oriented as shown. Peel the paper backing off
the pad on the bottom of the receiver. Press the
receiver onto the Pulse Receiver Cover (95) in
the location shown.
3. Connect the wire on the receiver to the wire ex-
tending from the console assembly. Make sure
that no wires are pinched. Reattach the Pulse
Receiver Cover (95) to the console assembly
with the #8 x 1/2" Screw (17). Discard the other
wires included with the receiver.
1
17
2
3
17
12
Console
95
Assembly
Receiver
Antenna
95
Wires
Console
95
Assembly