Page 1
Refrigerator Instructions for installation and use...
Page 2
0-star refrigerator Instructions for installation and use To maintain the EFFICIENCY and SAFETY of this appliance, we recommend: - use only the MANUFACTURER Service - use only ORIGINAL Spare Parts...
5. Never pull on the cord or the refrigerator to remove the plug from the wall socket - this is very dangerous. 6. Never touch the cooling components within the appliance, especially with wet hands because this could result in injury.
Installation To ensure that the appliance operates properly and to reduce energy consumption, it is important that the appliance is installed correctly. Ventilation The compressor and condenser generate heat and, therefore, need to be ventilated properly. Rooms with less than perfect ventilation are not very suited for installation of the appli- ance.
Electrical connection Your appliance is now supplied with a 13 amp fused plug that can be plugged into a 13 amp socket for immediate use. Before using the appliance please read the instructions below. WARNING - THIS APPLIANCE MUST BE EARTHED. THE FOLLOWING OPERATIONS SHOULD BE CARRIED OUT BY A QUALIFIED ELECTRICIAN.
Temperature regulation knob Use this knob to regulate the temperature of the refrigera- tor. To following settings are available: refrigerator OFF; 1 minimum cold temperature; 5 maximum cold temperature Removable shelf with lid and egg compart- ment Removable door shelf for food products...
- Air in the refrigerator circulates naturally so that cold heavier air tends to fall towards the bottom. This is why meat and fish should be stored just above the crisper.
- Never Put Food in the Refrigeror while Still A container of hot food in the refrigerator will increase the temperature significantly; allow food to cool to room tem- perature before storing.
· Remember that the refrigerant in the cooling circuit causes a slight bubbling sound, even when the compressor is not running (this is quite normal). There is Water on the Bottom of the Refrigerator Check whether: · The defrost drain is clogged.
Need help?
Do you have a question about the SA300 I and is the answer not in the manual?
Questions and answers