Starting A Program; Program Progress; Washing Cycle Complete/Removing The Washing - AEG LAVAMAT 86810 User Information

Starting a program

1. Check that the water tap is open.
2. Press the
The program is started or it starts after the time delay set has elapsed.
3
If after pressing the
not Closed", the door has not been shut properly. Push the door firmly
closed and press the

Program progress

The display indicates the
stage of the program that is
currently being performed as
well as the time of the end
of the program.
3
During the washing cycle the
time of the end of the pro-
gram may change as the
program adjusts itself to different conditions (e. g., type and quantity
of laundry, out of balance spin detection, special rinses, etc.).

Washing cycle complete/Removing the washing

At the end of the cycle a long acoustic signal sounds 3 times (when the
SOUND setting is NORMAL or LOW) and the messages "Cycle ended"
and "Door openable" appear alternately in the display.
1. Open the door and remove the washing.
2. Turn the programme knob to
3. After the wash, pull out the detergent dispenser drawer slightly to al-
low it to dry. Leave the door slightly open to air the inside of the wash-
ing machine.
If RINSE HOLD
After a RINSE HOLD or when a program with NIGHT CYCLE has ended,
the
locked" appear alternately in the display.
The water must first be drained:
– Turn the programme knob to
START/PAUSE key (the water is drained without spinning),
or
18
START/PAUSE key.
START/PAUSE key the display shows "Door
START/PAUSE key again.
or NIGHT CYCLE
START/PAUSE indicator flashes. "Cycle ended" and "Door
LINEN/EASY CARE
Washing
50C 800 aýýýýýaýaýaýaýaýaýaýaýa
t u
OFF.
was selected:
OFF, then to
12.45
14.37
o O z
DRAIN and press the