Cleaning And Storage; Troubleshooting - LEHR BV025HH Operator's Manual

CLEANING AND STORAGE

CLEANING
• Use a small soft brush to clean the outside of the
unit. Do not use strong detergents. Household
cleaners that contain aromatic oils such as pine
and lemon, and solvents such as kerosene, can
damage plastic housing or handle. Wipe o any
moisture with a soft cloth.
• Empty the vacuum bag. Turn it inside out and shake
off any excess debris. Hand wash the empty vacuum
bag annually with soapy water and allow to air dry.
STORAGE
• Remove propane canister.
• Never store the unit with attached propane canister
where fumes may reach an open ame or spark.
• Allow the engine to cool before storing.
• Lock up the unit to prevent unauthorized use or
damage.
• Store the unit in a dry, well-ventilated area.
• Store unit out of reach of children.
WARNING:
TO AVOID SERIOUS INJURY, ALWAYS
TURN YOUR UNIT OFF AND ALLOW IT
TO COOL BEFORE YOU SERVICE IT.
ENGINE WILL NOT START
CAUSE
EMPTY PROPANE CANISTER
CAGE DOOR NOT CLOSED
VACUUM TUBE NOT PROPERLY INSTALLED INSTALL VACUUM TUBE PROPERLY
ENGINE WILL NOT IDLE
CAUSE
AIR FILTER IS PLUGGED
IMPROPER CARBURETOR ADJUSTMENT
ENGINE WILL NOT ACCELERATE
CAUSE
DIRTY AIR FILTER
ENGINE LACKS POWER OR STALLS WHEN IN USE
CAUSE
BAD SPARK PLUG
IF FURTHER ASSISTANCE IS REQUIRED, CONTACT LEHR AT 1-866-941-5347
LEHR |
16
ALL RIGHTS RESERVED 2009-2010
LONG TERM STORAGE
1. Remove propane canister.
2. Allow the engine to cool. Remove the spark
plug and put 5 drops of high quality motor oil
into the cylinder. Pull the starter rope slowly to
distribute the oil. Reinstall the spark plug.
NOTE: Remove the spark plug and drain all of the
oil from the cylinder before attempting to start
the unit after long term storage.
3. Change the oil, referring to Changing the Oil
(p.13). Dispose of the old oil in accordance to
Federal, State and Local regulations.
4. Thoroughly clean the unit and inspect for any
loose or damaged parts. Repair or replace
damaged parts and tighten loose screws, nuts
or bolts. The unit is ready for storage.
TRANSPORTING
• Allow the engine to cool before transporting.
• Secure the unit while transporting.
• Remove propane canister.
TROUBLE SHOOTING
ACTION
INSTALL FULL CANISTER
CLOSE THE CAGE DOOR
ACTION
REPLACE THE AIR FILTER
ADJUST ACCORDING TO THE 'CARBURETOR
ADJUSTMENTS' SECTION OR TAKE TO AN
AUTHORIZED SERVICE DEALER FOR AN ADJUSTMENT
ACTION
CLEAN OR REPLACE THE AIR FILTER
ACTION
REPLACE SPARK PLUG