Asko D5233 Operating Instructions Manual page 30

Installation and connection information
wATER CONNECTION
• The machine can be connected to a cold
or hot water supply (maximum 10°F,
8°C). However, we recommend connec-
tion to a cold water supply.
• The inlet pipe has a connector with either
a 9/1" internal thread depending on the
country.
ElECTRICAl CONNECTION
• 10VAC mains voltage, minimum 1A.
dRAINAgE
• The supplied cone-shaped connector fits a
drain connection with an internal diameter
of 1/, /8, / and 7/8
18 and  mm).
• Use a hose clamp if connecting to a fixed
drain (sink).
The connector is ready to cut to the desired
drain connection size. Only a clamp is re-
quired.
CAblE/hOSE lENgThS
Drain hose:
Supply hose:
Power cable:
TOOLS
1) Flathead screwdriver
) Open-ended wrench
/8 inches (1 mm)
) Tape measure
) Spirit level
0
inches (1, 1,
9 inches (190 mm)
 inches (170 mm)
 inches (1770 mm)
Customer Care Center
1-800-898-1879
www.askousa.com