Amana IC56 Installation And Operating Instructions Manual
Amana IC56 Installation And Operating Instructions Manual

Amana IC56 Installation And Operating Instructions Manual

International top freezer refrigerator ice maker kit

Advertisement

Quick Links

®
IC56
International
Top Freezer
Refrigerator
Ice Maker Kit
Installation and
Operating
Instructions
Keep these instructions for future reference. Be sure this
manual stays with refrigerator.

Advertisement

Table of Contents
loading

Summary of Contents for Amana IC56

  • Page 1 ® IC56 International Top Freezer Refrigerator Ice Maker Kit Installation and Operating Instructions Keep these instructions for future reference. Be sure this manual stays with refrigerator.
  • Page 2: Table Of Contents

    • Before connecting ice maker, contact a plumber to connect copper tubing to household plumbing in compliance with local codes and ordinances. • Amana is not responsible for property damage due to improper installation or water connection. 6 mm ( ") flexible copper tubing*.
  • Page 3: Parts

    Parts Use listed part numbers only when ordering replacement parts. Part numbers are not used in installation instructions. Item Description Part Quantity Item Description Part Quantity Number number Ice maker D7846305 Anti-kink spring A1055101 (inside 6.35 mm O.D. plastic tube) Ice maker cover 10519801 Stainless steel insert...
  • Page 4: Procedure

    Procedure 1. Turn off water supply to refrigerator. WARNING CAUTION To avoid electrical shock which can cause severe personal injury or death, ground wire must be properly To avoid property damage, protect soft vinyl or other attached to both bracket and water valve. flooring by adjusting leveling legs up, off of floor before 6.
  • Page 5 10. Remove plastic cap from water valve tube fitting. Connect copper tubing service loop to water valve with DO NOT REMOVE THIS COVER UNLESS INSTALLING AN nut and sleeve. ICE MAKER Water fill tube inlet hole plug Rear of refrigerator Plastic 16.
  • Page 6 21. Start 16 mm ( ") long sheet metal screw in top front Important hole using 6.35 mm ( ") hex socket and driver. Leave Ice maker can be installed one way only. Do not drill head out approximately 9.65 mm ( ").
  • Page 7: Operating Instructions

    Operating Instructions Before Calling For Service • Confirm ice bucket is in place and ice maker arm is Allow ice maker 1 overnight period to make ice before down. assuming a difficulty exists. If ice maker is not producing ice •...
  • Page 8: Warranty

    Warranty Ice Maker Limited One Year Warranty First Year Amana Appliances will provide a free replacement part, f.o.b. Amana, Iowa, U.S.A., for any part which is defective due to workmanship or materials. Warranty Limitations Owner's Responsibilities • Begins at date of original purchase.

Table of Contents