Setting The Clock; Setting The Automatic Open Function - Pioneer AVH-P7650DVD Operation Manual

Other Functions
2 Touch a to turn rear view camera set-
ting on.
# To turn rear view camera setting off, touch b.
3 Touch c or d to select an appropriate
setting for polarity.
Each time you touch c or d it switches be-
tween the following polarity:
! BATTERY  When the polarity of the con-
nected lead is positive while the gear shift
is in REVERSE (R) position
! GND  When the polarity of the connected
lead is negative while the gear shift is in
REVERSE (R) position

Setting the clock

Use these instructions to set the clock.
! When this unit is turned on, time is dis-
played on the entertainment clock only.
(Refer to Switching the background display
on page 89.)
1 Touch A.MENU and SETUP and then
touch CLOCK ADJUST.
2 Touch c or d to select the segment of
the clock display you wish to set.
Each time you touch c or d it will select one
segment of the clock display:
HourMinute
As you select segments of the clock display
the segment selected will be highlighted.
3 Touch a or b to set the clock.
Each time you touch a it increases the se-
lected hour or minute. Each time you touch b
it decreases the selected hour or minute.
Notes
! You can match the clock to a time signal by
touching JUST.
 If the minute is 0029, the minutes are
rounded down. (e.g., 10:18 becomes
10:00.)
 If the minute is 3059, the minutes are
rounded up. (e.g., 10:36 becomes 11:00.)
! You can display the clock for eight seconds by
pressing FLIP DOWN/CLOCK when the LCD
panel is closed.
! Even when the sources are off, the clock dis-
play appears on the display.
Setting the automatic open
function
To prevent the display from hitting the shift
lever of an automatic vehicle when it is in P
(park) position, or when you do not wish the
display to open/close automatically, you can
set the automatic open function in the manual
mode.
1 Touch A.MENU and SETUP and then
touch AUTO FLAP.
2 Touch either of the following touch
panel keys to select the display to open/
close automatically or manually.
! AUTO  The LCD panel will be opened or
closed automatically with the turning of the
ignition switch on or off
! MANUAL  You have to press
OPEN/CLOSE to open/close the LCD
panel
Section
17
87
En