JVC AV-65WP74/HA Service Manual page 62

AV-65WP74
Measuring
Item
instrument
WHITE Signal
generator
BALANCE
(HIGH LIGHT)
Remote
adjustment
control unit
NTSC
Setting Item
Item
S10
S12
SUB BRIGHT Signal
generator
adjustment
Remote
control unit
Signal
Item
STANDARD
S03
1-62 (No.52096)
Test point
[1.PICTURE/SOUND]
S10: DRIVE R
S12: DRIVE B
1. PICTUER/SOUND
FULL DA H FL MUTE
S10 DRIVE R
INITIAL SETTING VALUE
Setting value
NTSC 480i
073 074
060 058
[1.PICTURE/SOUND]
S03: BRIGHT
Setting value
NTSC 480i
THEATER STANDARD THEATER
131 121 130 129
Table 1
Adjustment part
(1) Receive NTSC black & white signal (color off).
(2) Select STANDARD mode with [VIDEO STATUS]
key.
(3) The COLOR TEMP is set at LOW mode.
(4) Select 1.PICTER/SOUND from SERVICE MENU.
(5) Select <S10> (DRIVE R) or <S12> (DRIVE B).
(6) Adjust <S10> or <S12> so that the natural white
should be visible.
(7) Press [MUTING] key and memorize the set values.
(8) Input 480i component black & white signal from
COMPONENT VIDEO terminal.
(9) Repeat steps 5 ~ 7 above.
(10) Input 1080i component black & white signal from
COMPONENT VIDEO terminal.
(11) Repeat steps 5 ~ 7 above.
Setting value
1080i
074
058
(1) Receive NTSC black & white signal.
(2) Select STANDARD mode with [VIDEO STATUS]
key.
(3) The COLOR TEMP is set at the LOW mode.
(4) Select 1.PICTURE/SOUND from SERVICE MENU.
(5) Select <S03> (BRIGHT).
(6) Set initial setting value. (See Table1)
(7) If the brightness is not the best with the initial setting
value, make fine adjustment until you get the best
1080i
brightness.
STANDARD THEATER
(8) Press [MUTING] key and memorize the set values.
130
130
(9) Select THEATER mode with [VIDEO STATUS] key.
(10) Select 1.PICTURE/SOUND from SERVICE MENU.
(11) Select <S03>.
(12) Set initial setting value. (See Table1)
(13) If the brightness is not the best with the initial setting
value, make fine adjustment until you get the best
brightness.
(14) Press [MUTING] key and memorize the set values.
(15) Input 480i component black & white signal from
COMPONENT VIDEO terminal.
(16) Repeat steps 2 ~ 14 above.
(17) Input 1080i component black & white signal from
COMPONENT VIDEO terminal.
(18) Repeat steps 2 ~ 14 above.
Description