JVC AV-65WP74/HA Service Manual page 18

AV-65WP74
2.7.15 AV TERMINAL BOARD
• Take out the REAR PANEL
(1) Remove 9 screws [ U ].
(2) Remove 1 screws [ V ].
(3) Pull out the POWER CORD CLAMP from AV TERMINAL
BOARD left side.
(4) Remove the nut [ W ] attaching the ANTENNA TERMINAL.
(5) Take out the AV TERMINAL BOARD.
2.7.16 DIGITAL INPUT MODULE
• Take out the REAR PANEL
(1) Remove 2 screws [ X ] from rear side of the AV TERMINAL
BOARD.
(2) Take out the DIGITAL INPUT MODULE.
NOTE :
• When removing the DIGITAL INPUT MODULE, refer to
the "CAUTION AT DISASSEMBLY" section on page 14.
2.7.17 MAIN CHASSIS
• Take out the REAR PANEL.
• Take out the AV JACK BOARD. (Refer to next page)
• Take out the LINE FILTER BRACKET.
(1) Remove 2 screws [ Y ] both side of the MAIN CHASSIS.
(2) Remove 1 screws [ Z ] attaching the earth wire.
(3) Pull out the MAIN CHASSIS for back side.
NOTE :
• If necessary, remove the anode wires, connectors,
respectively.
1-18 (No.52096)
X
DIGITAL INPUT
MODULE
W
ANTENNA TERMINAL
POWER CORD CLAMP
Fig.9
Y
MAIN CHASSIS
Y
Fig.10
AV TERMINAL
BOARD
V
U
EARTH WIRE
Z