JVC AV-65WP74/HA Service Manual page 6

AV-65WP74
1.2.1.3 REASSEMBLY PROCEDURE
• Make sure that power cord is pulled out from the AC wall
socket.
• Remove the Top Sheet which covers the lower unit.
(1) Lift the upper unit slowly, and then place the upper unit on
the lower unit.
• In placing the upper unit on the lower unit, be careful not
to insert the connector for the auto-convergence on the
right side of the upper unit between the upper unit and
the lower unit.
(2) Adjust the front side of the upper unit to the brackets on the
lower unit for attaching the upper unit.
(3) Attach 2 screws [ A ] to the both side of the rear cover.
[Fig.2]
(4) Attach 2 screws [ A ] to the both edge of the rear cover.
[Fig.2]
(5) Attach the 4 screws [ A ] to the front panel bracket. [Fig.2]
(6) Attach the VOID seal [ b ] on the front right side of the set
to the right front panel bracket. [Fig.5]
(7) Attach the speaker grill to the front side.
(8) Attach 4 screws [ D ] to the both edge of the rear cover.
[Fig.2]
(9) Attach the 2 screws [ B ] to the front door. [Fig.2]
(10) Attach the connector for the auto-convergence sensor.
• Make sure that all the screws are attached certainly in
order to fix the upper unit.
• After assembly procedure is completed, make sure that
there is no dust in the inner side of the screen.
1-6 (No.52096)
b
Fig.5