Pioneer GEX-P5750TV Installation Manual page 5

1. AV-BUS cable
(supplied) 2. AV receiver
(e.g. AVH-P5750DVD)
(sold separately)
3. Yellow
6. Blue
5. Vehicle Dynamics Processor 4. Black
(e.g. AVG-VDP1)
(sold separately)
7. 26-pin cable
3. Yellow
3 m
(supplied with Vehicle Dynamics Processor)
8. IP-BUS cable
9. To video output
(supplied)
12. Display
(e.g. AVD-W8000)
3. Yellow
3 m
(sold separately)
4. Black
10. RCA cable
(sold
separately)
11. This unit
4. Black
6. Blue
14. To video
1 input
13. IP-BUS cable
3. Yellow
(sold separately)
15. To video 2
input
18. DVD Player
16. White/Red
(e.g. XDV-P9—)
4. Black
(sold separately)
17. RCA cable
( supplied with
DVD player)
10. RCA cable
3. Yellow
6. Blue
(sold separately)
19. Multi-CD Player
(sold separately)
4. Black 1. AV-BUS cable (supplied)
16. White/Red 50 cm 4. Black
1. AV-BUS cable (supplied)
4. Black 3 m
6. Blue Fig. 13
20. Use AV-BUS cable (50 cm ) if necessary.
2. AV-BUS input
1. Blue
3. Pioneer head unit
(sold separately)
4. AV system display 7. IP-BUS input
1. Blue
(e.g. AVX-P7650)
5. AV-BUS cable
(sold separately)
(supplied)
3 m
6. Black
8. This unit
6. Black
3 m
Fig. 14
9. IP-BUS cable
(supplied)
2. Display
(e.g. AVD-W8000)
(sold separately)
1. To video 1 input
3. Remote sensor
4. RCA cable
(supplied)
(sold separately)
6. Yellow
5. To video input
3 m
7. To rear out
(REAR OUT)
9. To front out
(FRONT VIDEO OUT)
8. Black
11. Display unit with RCA input jack
(sold separately)
Fig. 15
10. This unit
Fig. 16
1. This unit
3. Yellow
To terminal always supplied with power
2. Fuse holder
regardless of ignition switch position.
5. Red
4. Fuse resistor (Connect this lead only when this unit
is used as STAND ALONE mode.)
To electric terminal controlled by
ignition switch (12 V DC) ON/OFF.
6. Black (ground)
To vehicle (metal) body
7. Connection method .
8. Clamp the lead. 9. Clamp firmly with
needle-nosed pliers.
10. Note:
• The position of the parking brake switch depends
on the vehicle model. For details, consult the
vehicle Owner's Manual or dealer.
14. Parking brake switch
11. Light green
Used to detect the ON/OFF status of
the parking brake. This lead must be 12. Power supply side
connected to the power supply side of
13. Ground side
the parking brake switch.
Fig. 17