Electrolux E30GF74GPS Installation Instructions Manual page 24

24
Conversion To LP Gas
CONVERT TOP BURNER FOR USE WITH
LP/PROPANE GAS
CA CA UTION UTION
CAUTION CA CA UTION UTION
Save the natural gas orifices removed from the appliance for possible future
conversions to natural gas. Take extra care when handling steel parts.
a. Remove top grates, burner caps and inner burner rings.
b. Lift off outer burner heads and burner bases.
c. Remove the factory installed natural gas orifices from the center of the orifice
holders using a 7mm nut driver. Remember to keep the original natural
gas orifices for future conversions back to natural gas. Refer to page 22 under
"IMPORTANT" to identify their markings.
d. Using a 9/32" nut driver, replace the main orifice in each orifice holder with orifice
size (#58). Tighten each orifice until snug. Use caution not to over tighten.
e. Using a 5/32" nut driver, replace the Simmer orifice in each orifice holder with the
orifice size (0.46).
f. Replace the outer burner heads back to the main burner bases. Replace the inner
burner rings, burner caps and grates.
a.
c.
b .
e.