AiP 960H Series Instruction Manual

Speed dome camera
Table of Contents

Advertisement

Quick Links

AiP 960H Series

Speed Dome Camera

INSTRUCTION MANUAL

Advertisement

Table of Contents
loading

Summary of Contents for AiP 960H Series

  • Page 1: Speed Dome Camera

    AiP 960H Series Speed Dome Camera INSTRUCTION MANUAL...
  • Page 2: Key Features

    Executive Summary H.264 D1 video server or AiP camera uses the latest compression technologies providing 4-Streaming of H.264 and JPEG in different resolutions. 4-Streaming technologies allow transmitting digital video at various bitrate and frame rate to fit both high and low bandwidth network environment.
  • Page 3 AI HTTP API For non-ONVIF integration, please see AI HTTP API document. We adopt HTTP API document for all AI AiP cameras. Caution  Do not drop or strike this equipment  Do not install the equipment near any naked flames or heat sources ...
  • Page 4: Table Of Contents

    Chapter 2-3 Internet Browser Setting & Software Component Required ... 7 Chapter 2-4 Login ....................7 Chapter 3 Start Using the Camera ................9 Chapter 3-1 AiP camera Operational HTML Page ..........9 Chapter 3-2 PTZ Control Panel ................9 Chapter 3-2-1 PT Mode ................10 Chapter 3-2-2 ePTZ ..................
  • Page 5 Chapter 3-5-2 Weighted Streaming Mode ........... 20 Chapter 3-5-3 Video Quality ................ 21 Chapter 3-6 PTZ Settings ................. 21 Chapter 3-6-1 PTZ Advanced Settings ............21 Chapter 3-6-2 PTZ Schedule Settings ............22 Chapter 3-7 SD Card Recording ............... 23 Chapter 3-7-1 SD Card Recording Setting ..........
  • Page 6: Chapter 1 System Overview

    AI Universal ActiveX software components are required for web interface for displaying JPEG or H.264 video. When you first time login the AiP camera using Internet Explorer, it prompts for a security warning dialog box for downloading AI Universal ActiveX. Please click on Install button to download.
  • Page 7: Chapter 2 Before Accessing Aip Camera

    Chapter 2 Before Accessing AiP camera Before accessing to the AiP camera, make sure that the camera’s RJ-45 network cable, audio cable, and AiP camera’s power cable are properly installed. For setup IP address, please consult your network administrator for available IP addresses. The default IP address of AiP camera is 192.168.0.200.
  • Page 8: Chapter 2-2 Configure Ip Address Using Html Page

    After finishing above security settings, accessing H.264 D1 video server or AiP camera’s live video by default IP address of H.264 D1 video server or AiP camera using Internet Explorer will prompt a Security Warning dialog box. Click on OK button to download the ActiveX directly from H.264 D1 video server or AiP camera.
  • Page 9 The default settings of username and password are described as follows: Administrator Guest Username admin guest Password pass guest To logon the H.264 D1 video server or AiP camera, please type username and password in logon HTML page and click on Submit button to enter the system.
  • Page 10: Chapter 3 Start Using The Camera

    Chapter 3 Start Using the Camera After login H.264 D1 video server or AiP camera as administrator, there are two main features—system operation and configuration. Operation and configuration features are described as follows: Chapter 3-1 AiP camera Operational HTML Page Operational HTML page layout 1.
  • Page 11: Chapter 3-2-1 Pt Mode

    Auto Iris: Set the device to auto Iris mode. Focus +: Focus far Focus -: Focus near Auto Focus: Set the device to auto focus mode. OSD Enter: Enter PTZ device’s internal setting. Exit PTZ device’s internal setting. OSD Esc: Wide: Lens zoom out Tele:...
  • Page 12: Chapter 3-2-2 Eptz

    Pan mode at absolute position Absolute position Pan and tilt modes at absolute position Absolute position Tilt lens Chapter 3-2-2 ePTZ To perform ActiveX ePTZ feature, please use a computer mouse to drag on the ActiveX control. AI Universal ActiveX control becomes eZoom mode. Please use computer mouse pointing to the sub-window of PIP view.
  • Page 13: Chapter 3-2-3 Camera Control Panel

    To stop listening to the remote site, please click on Speaker icon again. Note: Only AiP camera models with audio can support this feature. Chapter 3-2-5 Record in a Local PC To record into a local PC, please first right-click on AI Universal ActiveX control. It shows up in the setting dialog box.
  • Page 14: Chapter 3-3 Configurations

    The device name can be used by IPScan utility to identify the H.264 D1 video server or AiP camera To change the device name, enter the name for H.264 D1 video server or AiP camera and click on Submit button.
  • Page 15: Chapter 3-3-3 Timer

    Chapter 3-3-3 Timer H.264 D1 video server or AiP camera allows a user to change system timer via standard HTML web page. To change H.264 D1 video server or AiP camera’s system timer, please enter the date and time in the edit boxes. Click on Submit button to apply this operation.
  • Page 16: Chapter 3-3-4 System Setting

    DDNS. A user can configure these Internet protocol settings. To setup above, please read the following sections: Chapter 3-4-1 General Settings Network general settings are the basic settings connecting H.264 D1 video server or AiP camera to the network. The default IP Address of H.264 D1 video server or AiP...
  • Page 17: Chapter 3-4-2 Dhcp Setting

    Router, gateway, or other software DHCP servers can dynamically assign an IP address to the H.264 D1 video server or AiP camera. There is no need to configure IP address, subnet mask, and gateway. Since the DHCP may assign a different IP address to the H.264 D1 video server or AiP camera after power off, a user can use IPScan utility to...
  • Page 18: Chapter 3-4-4 Smtp Service

    Note: For low latency application, please select RTSP/UDP streaming option. Chapter 3-4-4 SMTP Service Alarm or motion notification feature can send an alarm or motion detection snapshot to an E-mail account. To enable alarm or motion sending E-mail feature, please setup the following email accounts.
  • Page 19: Chapter 3-4-6 Ddns Settings

    To use www.ddnsipcam.com, you can use the last 6 digits of the MAC address for the host name and default account. The default password is "pass". If the AiP camera is on Internet with global IP address, you can access it directly the AiP camera by using DDNS host name.
  • Page 20: Chapter 3-5 Video Settings

    Chapter 3-5-1 Video General For transmitting H.264 video over low bandwidth network such as Internet, please set the bit rate close to network upload bandwidth. H.264 AiP camera can encode video frames based on the bit rate setting.  Profiles: Selections of streaming combination ...
  • Page 21: Chapter 3-5-2 Weighted Streaming Mode

    Chapter 3-5-2 Weighted Streaming Mode Weighted streaming mode is activated when an alarm went off. The streaming goes to the maximum speed, for example 30 FPS. If there is no alarm activity, the streaming stays one frame per second for saving bandwidth and storage.
  • Page 22: Chapter 3-5-3 Video Quality

    Alarm Interval Chapter 3-5-3 Video Quality To setup video quality, please adjust brightness, contrast, hue, saturation, and sharpness accordingly. Chapter 3-6 PTZ Settings To setup PTZ preset points, please select Camera ID (RS-485ID) first. For RS-485ID, please refer to PTZ user manual for detail. Once RS-485ID has been set, please select preset point.
  • Page 23: Chapter 3-6-2 Ptz Schedule Settings

    Chapter 3-6-2 PTZ Schedule Settings To setup PTZ scheduling, please select PTZ schedule link. Use the mouse select on the radio button of the preset types, None, Autopan, Preset #1, Preset #2, Preset #3, and Preset #4. Click on the hour of the calendar control to configure the preset action.
  • Page 24: Chapter 3-7 Sd Card Recording

    Chapter 3-7 SD Card Recording To record video on SD Card, please insert SD card into the SD card slot. Enable SD card recording feature. The AiP camera can start to record video into the SD card. Chapter 3-7-1 SD Card Recording Setting For SD card recording setting, please see the following for detail.
  • Page 25: Chapter 3-8 Alarm Settings

    FTP archiving can be found at this section. Chapter 3-8-1 Motion/Alarm Setup There are motion detection zones allowed in the H.264 D1 video server or AiP camera. A user can enable the detection zones with different sensitivities ranging from 1 to 99 (highest to lowest) for motion detection.
  • Page 26: Chapter 3-8-3 Motion Area

    To configure motion area, perform mouse click on the video area. Chapter 3-8-4 Audio Detection For audio model, the AiP camera has audio detector detecting acoustic level. If the volume exceeds the audio sensitivity value, audio detector triggers an alarm for...
  • Page 27: Chapter 3-9 Audio Setting

    Chapter 3-9 Audio Setting Audio setting is based on the following:  MIC Volume: MIC or line input volume  Audio Input Mode: Choose MIC input or Line input.  Audio Input Gain: Voice input gain magnification  Audio Output Volume: Line output volume adjustment ...
  • Page 28: Appendix

    AiP camera, H.264 AVC AiP camera notifies DDNS service. A remote PC can access H.264 AVC AiP camera by typing domain name in a browser. The domain name gets resolved by DDNS service and gets translated to its dynamic global IP address. The dynamic global IP address can now be accessed by the remote PC.
  • Page 29: Iphone Access

    Execute Live Cams Pro application. Please click on “Add Camera” button on your phone while using Live Cams Pro. Task bar gets prompted as below: Please selection one of the following drivers for cameras: Profile 1: H.264 HD or D1 AiP camera.
  • Page 30: Emergency Factory Default

    Please click on Manage Cameras button. A list of camera names shows on the screen. Please select one of the cameras and click on Edit button. “Add/Edit AiP camera” dialog box gets prompted for editing an AiP camera or a DVR. In “Add/Edit AiP camera” dialog box, please enter the following information: 1.
  • Page 31: Sd Card Compatibility List

    SD Card Compatibility List Manufacturer Size SDHC/SDSC Sandisk 16GB SDHC Sandisk SDHC Transcend SDHC Transcend SDHC Sandisk 32GB SDHC...
  • Page 32: Specification

    Specification Speed Video Dome Server Video compression H.264 and Motion JPEG, dual codec Resolution 960H: 960 x 480 (NTSC) / 960 x 576 (PAL) , D1: 720 x 480 , CIF: 352 x 240 H.264 : up to 30 (NTSC) / 25 (PAL) FPS at 960H resolution Frame rate Motion JPEG : up to 30 (NTSC) / 25 (PAL) FPS at D1 resolution Streaming...
  • Page 33 DISTRIBUTOR: AiP 960H Series Speed Dome...

Table of Contents