Maintenance - Delta 36-585 Instruction Manual

C
B
Fig. 47
BLADE CHANGING WRENCH STORAGE
You can store the blade changing wrench (A) Fig. 47 in the slot (B) behind the fence (C).
LOCKING CUTTINGHEAD IN THE DOWN POSITION
When transporting the saw, lock the cuttinghead in the down position. Lower the cuttinghead (A) Fig. 48 and push in
cuttinghead lock knob (B) until it engages with the hole in the cuttinghead.
REAR SUPPORT/STABILIZER & CARRYING HANDLE
Use the rear support/stabilizer and carrying handle to
carry the machine.
Carrying the machine by the switch
handle will cause misalignment.
Always lift and carry the machine by
the base or by the carrying handle (C)
Fig. 49.
Keep the rear support fully extended
during all cutting operations. Push the
rear support in only when storing the
machine.
CHANGING THE BLADE
Use only cross-cutting blades.
Do not use carbide-tipped blades with deep gullets. They can deflect and contact the guard.
Use only 10" " diameter saw blades that are rated for 5200 RPM or higher and have 5/8" " diameter
arbor holes.
Disconnect machine from power source.
STORAGE
A
A
C

MAINTENANCE

17
B
Fig. 48
Fig. 49