Operating A Specific Display With The Remote Commander - Sony FWD-42LX1 Operating Instructions Manual

Operating a Specific Display With the Remote Commander

Operating a Specific Display
With the Remote Commander
Using the supplied Remote Commander, you can
operate a specific display without affecting other
displays installed at the same time.
1
Press ID MODE ON on the Remote Commander.
Monitor index numbers appear in black characters
on the lower left menu on the screen. (Every
display is allocated an individual preset index
number from 1 to 255.)
For details, see "To change the index number" on page
40 (GB).
ON SET OFF
2
Input the index number of the display you want to
operate using the 0 – 9 buttons on the Remote
Commander.
The input number appears right next to the index
number of each display.
1 2 3
4 5 6
7 8 9
0
ON SET OFF
3
Press ID MODE SET.
The characters on the selected display change to
green while the others change to red.
ON SET
You can operate the specified display indicated
with green characters only.
(Power ON/STANDBY apply to the other
displays, as well.)
40
(GB)
Index number
Index Number 117 . . .
Input Number
Index Number 117 117
OFF
4
When all of the setting changes have been
completed, press the ID MODE OFF button.
The display returns to the normal screen.
ON SET
To change the index number
You can change the index number if necessary.
When you change the number, use the buttons on the
control button section of the display unit.
You cannot change the index number using the
Remote Commander.
1
Press MENU.
The main menu appears on the screen.
PICTURE/SOUND CONTROL
Picture Mode: Standard
Adjust Picture
Adjust Sound
Select Set
ENTER
2
Select "CUSTOM SETUP" and press ENTER.
The following appears on the screen.
CUSTOM SETUP
Power Saving: Standard
Speaker Out: Off
Closed Caption: Off
Display: Off
Color Matrix: Y/PB/PR
HD Mode: 1080i
RGB Mode: DTV
Sync Mode: H/Comp
Illumination: High
Remote
Select Set
ENTER
3
Select "Remote" with M/m and press ENTER.
The Remote menu appears on the screen.
CUSTOM SETUP
Remote
Index Number: 1
Control Mode: Display + Remote
Select Set ENTER
4
Select the index number with M/m and press
ENTER.
The menu returns to the Remote menu.
OFF
Exit
MENU
Exit
MENU
Exit MENU