Haier HWD1000 Service Manual page 22

Error message. Motor overheat protection or is damaged.
Troubleshooting:
Cut off power and check if motor wires
are connected well
Y
Pull out the wire connection of motor
Then check if circuit is open by multimeter
N
Replace display board
Error message: Water level is abnormal in the drying process
Troubleshooting:
check if the wire connected display
board and inlet valve is not properly.
N
Check if drain pump acts by touching
pump position
N
Cut off the power and choose spin programto
start, then check the import voltage of drain
pump, is it betwe en AC 120V?
N
Cut off powe r and pull out wate r level
press ure switch wire conne ction. Se t spin
program to start. Check the export voltage to
drain pump, is it between AC 120V ?
N
check if the stream adjuster
is broken.
N
Replace display board
Automatic Drum Washing Machine
Y
The wire between
drain pump is not connected properly.
Y
Replace the wire.
Y
Page 21
Reconnect well
N
Y
Please reconnected it
Check if drain pump or
drain pipe is jammed, and
Y
open the filter and clean
Y
Replacedrain pump
display board and
Please replace it
Model:HWD1000
Repair wires