Download Print this page
FRIEDLAND Wirefree AlarmInterface Module Installation And Operating Instructions Manual
FRIEDLAND Wirefree AlarmInterface Module Installation And Operating Instructions Manual

FRIEDLAND Wirefree AlarmInterface Module Installation And Operating Instructions Manual

Wirefree alarm interface module

Advertisement

Quick Links

Wirefree Alarm
Interface Module
Installation and Operating Instructions

Advertisement

loading
Need help?

Need help?

Do you have a question about the Wirefree AlarmInterface Module and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for FRIEDLAND Wirefree AlarmInterface Module

  • Page 1 Wirefree Alarm Interface Module Installation and Operating Instructions...
  • Page 2 Installation and Operating Manual and the Smoke Alarm instructions, they should be retained for future reference. POSITIONING THE DECLARATION INTERFACE MODULE AND Friedland hereby declares that this SMOKE ALARM wirefree Alarm Interface Module is in compliance with the essential The Smoke Alarm and Interface...
  • Page 3 CONFIGURING THE Configuring the Interface INTERFACE MODULE AND Module: SMOKE ALARM 1 ) R e m o v e t h e r e a r c o v e r b y inserting a small coin between The procedures described in this the front and back covers and section should be undertaken gently twisting.
  • Page 4 have the DIP switches in a Remote Control set as shown. The indicator LED will illuminate for approximately 1 s. The corresponding settings of the house code DIP switches (1-8) in the Interface Module Testing the Interface Module: would be as follows: 7 ) Place the alarm system Control Panel into Test Mode and select Walk Test or Detector Test as...
  • Page 5 Connecting the Interface Testing the Smoke Alarm: Module to the Smoke Alarm: 11) Press and hold down the test 9) Connect the pre-fitted cable button on Smoke Alarm. from the Interface Module to – The Smoke Alarm siren should the terminals on the back of the activate.
  • Page 6 INSTALLING THE 1) Using the base as a template, INTERFACE MODULE AND mark the position of the two fixing holes on the ceiling. SMOKE ALARM The Interface Module is mounted 2) Drill two 5mm holes and fit the inside the Smoke Alarm mounting wall plugs.
  • Page 7 OPERATING INSTRUCTIONS When the Smoke alarm activates the Interface Module will be triggered and a “Fire” signal will then be sent to the alarm system which will trigger an alarm, (provided the alarm is not in test or Program Modes). The security alarm will continue until programmed alarm...
  • Page 8 2) Press and hold down the test cleaned using a soft damp cloth. button on Smoke Alarm. Do not use abrasive, solvent based or aerosol cleaners. Do not attempt T h e S m o k e A l a r m s i r e n to clean inside the unit or allow should activate.
  • Page 9: Troubleshooting

    6) Jumper Link S1 incorrectly set Note: Before removing the cover of – ensure link is fitted across pins the Interface Module first put the “G” and “C”. alarm Control Panel into Test Mod e t o avoi d t rig ge rin g an 7) Jumper Link S2 missing –...
  • Page 10 Recycling Centre. GUARANTEE Friedland undertakes to replace or repair at its discretion goods (excluding batteries) should they become defective within 2 years solely as a result of faulty materials and workmanship. Understandably if the...

This manual is also suitable for:

Wirefree alarm interface module