Page 1
THERMO POT MODEL: TP-3815 TP-5012 Owner’s Manual Please read this manual carefully before operating your set. Retain it for future reference Record model number and serial number of the set. See the label attached on the set and quote this information to your dealer when you require service.
Page 2
SAFETY Read this instruction manual carefully before operating the appliance and keep it for future reference. 1. Never immerse the appliance in water or any other liquids, nor rinse it under the tap. 2. Check if the voltage indicated on the appliance corresponded to the local mains voltage before you connect the appliance.
USING THE THERMO POT FOR THE FIRST TIME 1. Wash and rinse water tank with water. 2. Fill water up to full mark. 3. Boil once and discard the water by pumping it out. REMOVE AND ATTACH THE LID Detach Lid Place the handle towards the rear side of the thermo pot.
Page 5
Do not open the lid or dispense water while BOIL the water is boiling. Do not contact any parts of your body to the KEEP WARM steam vent. Do not place cloth or any other items to cover the steam vent.
It takes about 3 minutes to re-boil water To re-boil water under keep warm mode (with full water tank). Before re-boiling the water, make sure the water level is above the refill mark. When adding water into the water tank, be careful the hot steam from the steam vent and water tank.
Page 7
Red rust-like spots, milky or black Discoloration of the water tank and white floating objects in the water tank. discoloration, and white floating objects are caused by minerals in the water and are not caused by discoloration or deterioration of the water tank itself.
Page 8
HAZARDS Do not immerse the thermo Fill the water tank with tap Do not place the thermo pot pot, power cord or plug in the water (do not fill with milk or on unstable surfaces. water or other liquids to any other liquids).
IMPORTANT GUIDELINES WARNING: THIS APPLIANCE MUST BE EARTHED The wires in this main are colored in accordance with the following code: Green and yellow : Earth Blue : Neutral Brown : Live If the colors above do not match those terminals identified of the plug, connect as follows: The wire with the color of green and yellow must be connected to the terminal marked “E”...