Introduction to Lynx Vehicle Dock
Remote Control Battery Replacement
To replace the battery in the Remote Control, follow these steps:
1. Turn the Remote Control over and remove the battery cover. It is best if you remove the battery door by
inserting your fingernail in the center of the gap between the door and the back of the remote. Apply a little
pressure and the door will pop open.
2. Observe the orientation of the battery, then slide it out. The positive (+) side of the battery should face up,
matching the positive (+) on the battery contact.
3. Replace it with a CR2025 battery.
4. Replace the battery cover.
6