AGA marvel 61HK Installation & Operation Manual page 20

FULL OVERLAY PANEL INSTALLATION INSTRUCTIONS
BRASS EXTENSION
SPRING WASHER
NUT
LOCK
15/32 HOLE
13/16 COUNTER
BORE 7/16 DEEP
3/4 INCH
WOOD PANEL
Step 8: Assemble the lock parts
Two (2) lock extensions are supplied with the lock. Use
the longer extension for a
shorter one for a ⁄ " thick panel. Assemble the lock exten-
5
8
sion, cam stop washer, spring washer, and set screw to the
lock as shown in Figure 32 and 33.
Install this assembly into the overlay panel and secure with
the retaining nut using a 15mm socket. Make sure the key
slot in the lock is vertical.
Step 9: Secure overlay panel to the door.
With the #10 wood screws provided, fasten the overlay
panel to the door. (See Figure 34).
Step 10: Install lock cam (Models with locks
only).
Attach the lock cam to the back of the lock assembly with
the phillips head machine screw provided. Orient the lock
cam vertically when installing on the lock.
Step 11: Install door gasket
Press the door gasket into the door channel. Make certain
the gasket corners are fully inserted. If applicable insert
the key into the lock and make certain the lock operates
properly.
Step 12: Install the door
Install the top and bottom hinge adapter bushings back into
the hinge adapters that were removed in step 6. Install the
door by reversing the procedure from step 2. Install the top
hinge pin so the screw head is flush with the top surface of
the hinge. If applicable insert key into lock and verify the
lock cam works properly with the catch bracket on the front
of the refrigerator cabinet.
CAM
PHILLIPS SCREW
SECTION A-A
SCALE 1 : 1
Figure 33
⁄ " thick overlay panel and the
3
4
Clearance hole through
door gasket channel
#10 Wood Screw
Back of door
INNER
DOOR
Top hinge pin
Top door hinge
adapter
Top hinge adapter
bushing
Bottom door
hinge adapter
Bottom hinge
adapter bushing
Bottom hinge
cam
Bottom hinge pin
20
Figure 34
Top hinge
Bottom
hinge
Figure 35
Right Hand
Hinges shown