AGA marvel 61HK Installation & Operation Manual page 19

FULL OVERLAY PANEL INSTALLATION INSTRUCTIONS
This is also a convenient time to locate and drill the holes
for your handle. Most often the handle is to match that of
the surrounding cabinetry. If your handle attaches from the
back-side of the custom panel, locate the mounting holes
while the panel is attached to the door and cabinet. After
the panel is removed from the door, drill the mounting holes
from the front, to the recommended diameter of the handle
manufacturer. Counter bore the back-side of the panel so
the screw heads do not interfere with the surface of the
door.
Step 6: Drill panel mounting holes
Re-clamp the panel to the door per step 5 and drill the screw
pilot holes for attaching the overlay panel to the door. Select
the size of the hole from Table A. Be careful not to drill the
pilot holes through the overlay panel, (
⁄ " (19mm) and ⁄ " (15.7mm) panels ).
3 5
4 8
Material Type
Hardwood
1
Softwood
NOTE
If your refrigerator has a door lock proceed to Step 7. If
your refrigerator does not have a door lock proceed to
Step 9.
⁄ " (12.7mm) deep for
1
2
#8 Wood Screw
⁄ " (3.2mm) Diameter. Pilot Hole
8
⁄ (2.8mm) Diameter. Pilot Hole
7
64
Table C
1.234" (31.3mm)
.991" (25.2mm)
Step 7: Mark and drill lock hole.
Locate and mark with a pencil the location of the lock hole
on the overlay panel, this is the hole in the top corner of
the handle side of the door. Remove the clamp and re-
move the overlay panel from the door. On the backside of
the panel where you marked the lock location drill a
(20.5mm) diameter counter bore
the overlay panel. Drill a
through the overlay panel centered on the counter bore be-
ing careful not to splinter the wood on the face side of the
panel. (See Figure 31).
Figure 31
Figure 32
19
⁄ " (11.0mm) deep into
7
16
⁄ " (12.0mm) diameter hole
15
32
Top hinge
adapter
Hole in hinge
adapter
Door
Overlay
panel
Hole in
bottom
hinge adapter
⁄ "
13
16