Page 1
OPERATING INSTRUCTIONS COVERS MODELS 4804 AND 4810...
Page 2
8. Install the air filter (Page 6) • Use Traxxas Top Fuel™. It is a high quality castor/synthetic blended • Remove the black cap which covers the carburetor air intake. fuel, available in 10% or 20% nitro blends. It is the only fuel •...
If you must use a fuel other than those listed, contact Nitro 4-Tec for return or exchange after it has been run. TRAXXAS first, at 1-888-TRAXXAS, to find out if the fuel is safe for use with TRX engines.
TRANSMITTER and relays BLACK STEERING them to the SERVOS. SERVO WHITE SERVO - The SERVOS are the small motor units in the model which operate the steering, and throttle mechanisms. Contact Traxxas for assistance: 1-888-TRAXXAS. 972-265-8000 (outside USA). E-mail us at support@Traxxas.com...
Page 5
50/50 is the direction. You may need to adjust the corresponding trim control recommended setting while running the Nitro 4-Tec. after moving the servo-reversing switch. Contact Traxxas for assistance: 1-888-TRAXXAS. 972-265-8000 (outside USA). E-mail us at support@Traxxas.com...
Page 6
Loss of the radio signal can cause you to lose control of Start control box. Plug the the car. battery connector into the face of the control box. The Contact Traxxas for assistance: 1-888-TRAXXAS. 972-265-8000 (outside USA). E-Mail us at support@traxxas.com...
Page 7
• Do not drive the Nitro 4-Tec at night, on public streets, or in Intentionally driving in an abusive and rough manner will large crowds of people. only result in poor performance and broken parts. Contact Traxxas for assistance: 1-888-TRAXXAS. 972-265-8000 (outside USA). E-mail us at support@Traxxas.com...
Page 8
9. 3) If the engine did not start in step 2, prime it again and retry. Continue this sequence until the engine starts. Contact Traxxas for assistance: 1-888-TRAXXAS. 972-265-8000 (outside USA). E-mail us at support@Traxxas.com...
11) The steering servo saver will wear out over time. If the steering becomes loose, the servo saver should be replaced. 6) Check the tightness of the wheel nuts with a wrench. Contact Traxxas for assistance: 1-888-TRAXXAS. 972-265-8000 (outside USA). E-Mail us at support@traxxas.com...
Page 10
Use a 2.0mm allen wrench to adjust the shift point. NOTE: It is important that your Positive camber Negative camber engine is properly tuned and has Contact Traxxas for assistance: 1-888-TRAXXAS. 972-265-8000 (outside USA). E-mail us at support@Traxxas.com...
Page 11
(earlier shifts). Be careful not to loosen the adjustment settings for the Nitro 4-Tec with stock tires and inserts. screw too much or you may cause the screw and spring to fall out. Contact Traxxas for assistance: 1-888-TRAXXAS. 972-265-8000 (outside USA). E-mail us at support@Traxxas.com...
For example, using a one-hole piston with a lightweight oil will Installing the front body mounts 3x10mm Countersunk Self-tapping screws 3x14mm Washerhead Self-tapping screws Installing the rear body mounts Contact Traxxas for assistance: 1-888-TRAXXAS. 972-265-8000 (outside USA). E-mail us at support@Traxxas.com...
Tape the templates to the body. Use a Dremel™ motor tool or tapered reamer to make the holes in the body material. Nitro 4-T ec body mounting hole template Contact Traxxas for assistance: 1-888-TRAXXAS. 972-265-8000 (outside USA). E-mail us at support@Traxxas.com...
TRAXXAS. Drain all fuel and remove all batteries. Remember that new (before it is used), it will be repaired or replaced at Traxxas’ dis- the warranty only covers brand new products which are defective cretion.This warranty will not cover damage from wear, abuse, neglect,...
Page 15
39 Broken clutch shoe spring ........ Replace clutch shoe spring (page 15) 40 Loose flywheel ..........Replace flywheel nut (page 15) 41 EZ-Start motor pinion stripped ......Replace EZ-Start motor Contact Traxxas for assistance: 1-888-TRAXXAS. 972-265-8000 (outside USA). E-mail us at support@Traxxas.com...
Need help?
Do you have a question about the 4 Nitro Tec 4804 and is the answer not in the manual?
Questions and answers