How To Use Your Dryer - Indesit G75C Instructions For Installation And Use Manual

How to use your dryer

1. Plug in, switch
on electricity.
3. Open the door
by pressing and
releasing the front
panel in the position
shown.
5. Load the dryer
placing the
clothes carefully in
the drum pushing
them well towards
the back and
away from the
door seal. Close
the door.
8. Press the START
switch to commence
the drying pro-
gramme.
The 'Cool Tumble'
phase
8
WARNING: WHEN
SWITCHING ON
OR OFF, PLEASE
ENSURE THAT
YOUR HANDS
ARE DRY
9. When finished
open the door and
take out the laun-
dry. Clean and
replace the fluff fil-
ter, and empty the
water container.
About 10 minutes before the programme is completed, the heating
elements will be switched off and the programme enters the final
'Cool Tumble' phase. During this phase the fabric is cooled. You
should always allow the dryer to complete this phase.
By opening the door you can check the dryness of the load as often
as you wish and if you want to remove some items before they are
fully dry. (This is particularly useful for a mixed load where you want
to iron some items, but others are to be fully dried.) You will need
to press the start button after closing the door to re-start the
programme. See section 'The Controls'.
2. Sort your laun-
dry (see section
"Sorting Your
Laundry")
4. Always check
the following:
6. Select the rele-
vant heat setting
(see section "The
Controls")
10. Switch off elec-
tricity and remove
plug from socket.
FLUFF FILTER
is clean and in place
WATER CONTAINER
is empty and in place
CONDENSER
is clean and in place
7. Select the
required programme
or drying time. (see
section "The
Controls")
WARNING: WHEN
SWITCHING ON
OR OFF, PLEASE
ENSURE THAT
YOUR HANDS
ARE DRY