Pioneer CDX-M2096ZRN Service Manual page 36

CDX-M2096ZRN
6.3 ADJUSTMENT OF ELEVATION WHEN THE CD CORE UNIT HAS BEEN REMOVED
FOR MAINTENANCE
- Adjustment When Error Code 60 is Displayed Because of Malfunctioning Elevation
•Note :
Unlike the conventional mechanisms, the new mechanism detects the height of the stage using slide-variable
resistance.
To absorb dislocation of the stage height caused by differences in the mechanism and the CD core unit,
adjustment must be made for each CD-mechanism module using a variable resistor.
Normally, readjustment is not needed, as this has been adjusted at the factory. However, adjustment of elevation
is required according to the procedure explained below if an elevation error has occurred or if the CD core unit
has been removed.
•Purpose :
To adjust and confirm whether or not elevation operates correctly.
•Adjustment Method :
•Measuring Equipment: Millivoltmeter
•Measuring Points :
•Setting : Without a magazine in Test mode
CD CORE UNIT
•Confirmation Procedure
1. Enter Test mode, then select Multi-CD player.
2. Press key A to enter Mechanism Test mode.
3. Press key A twice to specify the amount of movement.
36
EREF, EPVO
With the mechanism placed upside-down (Place the CD mechanism module so that the
CD core unit is above.)
EPVO
EREF
The amount of movement
changes each time key A is
pressed.
maximum movement
Key A
during movement
Key A
Key A
minimum movement
mV meter
Examples of display
TRACK
TRACK
73
TRACK
75
TRACK
74
TRACK
73