Connecting A Video Device (Composite Video/ S Video Device)/Stereo Amplifier - Toshiba TD-Z551 User Manual

Connecting a video device (composite video/ S video device)/stereo amplifier

Connecting a video device (composite video/ S video device)/stereo amplifier
This monitor can be connected to a composite video or S video device or a stereo amplifier. Refer to the user's manual of
the composite video or S video device or the stereo amplifier for details. (Cables shown in the figure below are
commercially available.)
• To connect a video device to the VIDEO IN connector (VIDEO IN or S-VIDEO IN) on the monitor, use a BNC cable or an S
video cable. For connection to the audio input connector on the monitor, use an audio cable (ø3.5-mm stereo mini – RCA).
Connect the connectors of the audio cable (RCA) correctly. For connection to the VIDEO IN connector, select [VIDEO] using the
INPUT button on the monitor or the VIDEO button on the wireless remote control. For connection to the S-VIDEO IN connector,
select [S-VIDEO] using the INPUT button on the monitor or the S-VIDEO button on the wireless remote control.
• To connect two monitors, connect one end of a BNC cable to the VIDEO OUT connector of the first monitor and the other end to
the VIDEO IN connector of the second monitor.
• In the daisy chain connection, you can connect up to 5 monitors (when using 5-meter cables). However, the maximum
number of connectable monitors may be limited depending on the connected devices to be used. It is recommended to
check the number of connectable monitors in advance in your installation environment.
• When an analog signal is transmitted through the daisy chain, the picture quality such as brightness and sharpness
degrades at the latter devices in the daisy chain connection.
• When different monitors need to be adjusted so that their tint can be identical, such as when using multiple screens, it is
recommended to use a signal distributor (commercially available).
• When connecting a stereo amplifier to the monitor, be sure to turn off the power of the stereo amplifier. For connection to
the AUDIO ANALOG OUT connector on the monitor, use an audio cable (ø3.5-mm stereo mini – RCA). Connect the
connectors of the audio cable (RCA) correctly. Be sure to turn on the monitor first, and then turn on the stereo amplifier.
• The selected audio input signal is output from the AUDIO ANALOG OUT connector.
LCD display ( rst display)
AUDIO
ANALOG OUT
VIDEO OUT
BNC cable
Audio cable (ø3.5-mm stereo mini – RCA)
Audio cable
(ø3.5-mm stereo mini – RCA)
BNC cable
S video cable
AUDIO
ANALOG IN
VIDEO IN
S-VIDEO IN
To audio input
(Sample Illustration) 55"
Preparation for use
Connection procedure
(composite video/S video device)
To audio output
To video output
LCD display (second display)
To S video output
VIDEO IN
Stereo amplifi er
External speakers
Video device
27