Table of Contents
Advertisement
• Installed program on remote PC to send commands:
In general, the RS-232 commands are sent for
operating the implemented functions via serial port
and utility a suitable utility can be used such as
described below.
Connecting to the Display LAN port
Download and install the PuTTY software from the
following link first: http://www.putty.org/.
Run the software and enter the Display's IP address in
the field Host Name. Enter "1986" as a default value
in the field Port. Then select "Telnet" as Connection
type and click the Open button.
Note: Refer to the Connectivity section of this manual for
information on connecting the Display to a network and
displaying the IP address of the Display.
Use the commands in the RS232 Command Table
which can be found on Toshiba website.For
example, if "GETVOLUME" command is entered,
current volume level should be displayed on the putty
window as shown in the pictures below.
Another example;
Volume level can be changed by using "VOLUME"
command. After sending this command, you can verify
the changes from the Display.
The last example ;
When "GETSOURCE" command is entered, current
source should be displayed on the putty window as
shown in the picture below.
Connecting to the Display (RS232 port)
Run the software and select Serial as Connection
Type. Enter the Display's serial port in the field
Serial Line (in the following example it is COM4)
and "115200" in the field Speed. Then click the
Open button.
Video Wall Settings
Press the Menu button and enter the Video Wall
Settings menu under the System>Settings>More or
Signage Settings menu. Row Count, Column Count,
Cell and Offset options are available.
Row count: Adjust the desired number of Video Wall
"rows" by pressing Left/Right directional buttons. The
maximum number that can be set is 10. Column count:
Adjust the desired number of VideoWall "columns" by
pressing Left/Right directional buttons. The maximum
number that can be set is 10.
Cell: Each Video Wall unit is called "Cell". Adjust
the desired number of cells by pressing Left/Right
directional buttons. The maximum number that can
be set is 100.
Offset: Offset setting is used to adjust the refractions
at the sides of the picture depending on the bezel
thickness between Video Wall units (Cell). The
English - 23 -
Advertisement
Table of Contents
