Impex MARCY SM-6001 Owner's Manual page 13

STEP 4 (See Diagram 4)
A.) Attach the Butterfly Base (#37) to the Rear Vertical Frame (#8). Secure it with two M10 x 2
½" Carriage Bolts (#84), Ø ¾" Washers (#89), and M10 Aircraft Nuts (#90).
B.) Attach two Swivel Pulley Brackets (#35) to the open brackets on the Rear Vertical Frame
(#8). Secure each Bracket with one M10 x 2 ½" Allen Bolt (#81), two Ø ¾" Washers (#89),
and one M10 Aircraft Nut (#90). Do not over tighten the nuts and bolts. Make sure the
brackets are able to swivel on the bolts.
C.) Insert the axle on the Left Butterfly (#38) through the holes on the Butterfly Base from the
bottom. Secure it with one Lock Ring (#47), Ø ¾" Washer (#89), and M10 x ¾" Allen Bolt
(#76).
D.) Attach the Left Butterfly Arm Pad (#43) to the Left Butterfly. Secure it with two M8 x 2 1/8"
Allen Bolts (#74) and Ø 5/8" Washers (#88).
E.) Repeat Procedures C & D above to install the other side.
12
DIAGRAM 4