Kenwood TM-V708A Service Manual page 38

TM-V708A
Common section
Item
1. Setting 1) Power voltage:13.8V
2) Band A, Band B
VOL, SQL knob:MIN
2. Reset
PARTIAL OR FULL RESET?
If your transceiver seems to be malfunctioning,
initializing the transceiver may resolve the
problem. Use Full Reset to initialize all settings
that you have customized. Partial (VFO) Reset
does not initialize the following settings:
Memory channels
Memory channel lockout Call channels
Program scan channels
DTMF memory channels DTMF memory channel
Some of the VFO factory defaults are listed below:
Parameter
VFO freq.
Freq. step
Tone freq.
3. BPF adjust 1) Band A
FREQ.: 146.050MHz
SSG:5.01µV (-93Bm)
38
ADJUSTMENT
Measurement
Condition
Test-
equipment
Memory channel names
PM channels
names
Band A
144.000MHz 440.000MHz
5kHz 25kHz
88.5Hz 88.5Hz
1 2
SSG
D.V.M
Unit Terminal Unit
1. Press [MNU] to enter Menu mode.
2. Press [
press [OK].
3. Press [ ]/[ ] to select "RESET (1–9–7)", then
press [OK].
4. Press [ ]/[ ] to select Partial (VFO) Reset, PM
Reset, or Full Reset, then press [OK].
• A confirmation message appears.
Band B
• Press [ESC] to quit resetting.
5. Press [OK].
After switching the power OFF, you may press
[VFO] + POWER ON for Partial Reset, or [MR] +
POWER ON for Full Reset. This allows you to skip
steps 1 to 4.
You can also use the RESET button to perform Full
Reset.
Note : When in All-control Lock or Channel Display mode,
you cannot perform Partial Reset or Full Reset.
1
DATA connector
2
PANEL connector
3
MIC connector
4
RESET button
3 4
Press to perform Full Reset. No confirmation
message appears. Use this switch when the
microcomputer and/or the memory chip
malfunction because of ambient factors.
Rear panel ANT TX-RX
TX-RX SMV
Adjustment
Specifications/
Parts Method Remarks
]/[ ] to select "AUX (1–9–)", then
L204 To 1.8V or higher
L207 maximize
L209 voltage