Impex POWERHOUSE ELITE PHE 2000 Owner's Manual page 19

STEP 9 (See Diagram 9 & Lower Cable Loop Diagram)
A.) Attach the 156" Lower Cable (#36) to the opening on the Leg Developer (#8). Attach a
Pulley to the opening. Secure it with one M10 x 2 3/8" Allen Bolt (#79), two
½" Pulley Bushings (#61), and one M10 Aircraft Nut (#89).
B.) Draw the Cable underneath the Pulley to the open bracket on the Front Base Frame
(#3). Attach a Pulley to the bracket. Secure it with one M10 x 1 ¾" Allen Bolt (#80),
two ¾" Washers (#87), and one M10 Aircraft Nut (#89).
C.) Draw the Cable underneath the Pulley towards back of the machine through the
bottom openings on the Vertical Frame (#5) and Butterfly Pulley Bracket (#17) to the
open bracket on the Rear Base Frame (#2). Repeat Procedure B above to install a
Pulley with a L-shape Cable Bracket (#91).
D.) Draw the Cable underneath the Pulley then pull upward to the Double Floating Pulley
Bracket (#24) previously installed in STEP-8. Repeat the Procedure B above to install
a Pulley. After completing the entire cable system, come back to the Double Floating
Pulley Bracket and adjust the height of the lower Pulley to adjust the tightness of the
Cables.
E.) Draw the Cable around the Pulley then downward. Attach the Cable to an Angled
Double Floating Pulley Bracket (#23). Repeat Procedure B above to install a Pulley.
Let the Bracket hanging for now.
F.) Draw the Cable around the Pulley then upward to the opening on the Vertical Frame
(#5). Attach a Pulley to the opening. Secure it with one M10 x 2 ½" Allen Bolt (#78),
two 5/8" x 5/8" Pulley Bushings (#60), and one M10 Aircraft Nut (#89).
G.) Insert the Cable through a Nylon Ball Stopper (#96). Attach the Cable to a U-shape
Cable Connector (#90). Secure it with one M10 x 1 3/8" Allen Bolt (#81), two
Washers (#87), and one M10 Aircraft Nut (#89).
18
5/8" x
¾"