Table of Contents
Advertisement
44
CONTROLLING THE MULTIPLE PRODUCT
24. Natural Mode (in Tile mode) (Command: d j)
* Areas corresponding to the gap between each tile
are removed to give the screen image a more natural
look.
This function is only available when Tile Mode is
enabled.
Transmission
[d][j][ ][Set ID][ ][Data][Cr]
Data 00: Natural Mode off
01: Natural Mode on
Acknowledgement
[j][ ][Set ID][ ][OK/NG][Data][x]
25. OSD Menu (Command: k l)
* Turns the OSD menu on/off.
Transmission
[k][l][ ][Set ID][ ][Data][Cr]
Data 00: OSD off
01: OSD on
Acknowledgement
[l][ ][Set ID][ ][OK/NG][Data][x]
26. Time elapsed (Command: d l)
* Checks the use time of the product.
Transmission
[d][l][ ][Set ID][ ][Data][Cr]
Data FF: Read status
Acknowledgement
[l][ ][Set ID][ ][OK/NG][Data][x]
* The data value received is shown in hexadecimal.
27. Serial No. Check (Command: f y)
* Checks the serial number of the product.
Transmission
[f][y][ ][Set ID][ ][Data][Cr]
Data FF: Check product serial number
Acknowledgement
[y][ ][Set ID][ ][OK/NG][Data][x]
* Data is ASCII code.
28. SW Version (Command: f z)
* Checks the software version of the product.
Transmission
[f][z][ ][Set ID][ ][Data][Cr]
Data FF: Check software version
Acknowledgement
[z][ ][Set ID][ ][OK/NG][Data][x]
* The data value received is shown in hexadecimal.
29. Automatic Standby (Command: m n)
Enables the Automatic Standby function (the set
turns off after 4 hours).
Transmission
[m][n][ ][Set ID][ ][Data][Cr]
Data
00: Off
01: On
Acknowledgement
[n][ ][Set ID][ ][OK/NG][Data][x]
Advertisement
Table of Contents
