Samson Graphite 49 Owner's Manual page 19

Graphite 49 · USB/MIDI Keyboard Controller
Setup Mode
Selecting Velocity Curve for the Trigger Pads
Press the P.Curve key to select a velocity curve for the trigger pads. "P.Curve" will appear in the Op-
eration area of the display with its current velocity curve number in the data area. The Operation
area will then change to show the current velocity curve. The number will also blink under the
"Pad Vel" tag on the second row of the display. Use the DATA +/– buttons or enter the number by
pressing the numerical keys on the keyboard. Press the ENTER key or the ENTER button to confirm
your setting and to save it. The name of the velocity curve will be updated, and the value display
will stop blinking. Selectable curves are the same as keyboard velocity curves.
Switch the Local Control
The USB out from port 1 or 2 can be transmitted through the MIDI Out jack. This is controlled by
the Local setting. Press the Local key to switch the local control on or off. "Local" and its current
status will appear in the Operation area of the display and flash. Press the DATA+ button (or nu-
merical key 1) to turn Local Control on. Press the DATA– button (or numerical key 0) to turn Local
Control off. Press the ENTER key or the ENTER button to confirm your setting and to save it.
Reverse Slider Direction
Sliders can be reversed to be used as drawbars. Press the Drawbar key to switch the drawbar
feature on or off. "Drawb" and its current status will appear in the Operation area of the display
and flash. The default setting is Off. Press the DATA+ button (or numerical key 1) to turn Drawbar
on. Press the DATA– button (or numerical key 0) to turn Drawbar off. Press the ENTER key or the
ENTER button to confirm your setting and save it in the current preset.
Pedal Setup
Press the pedal to assign a control code to the pedal. "Pedal" will appear in the Operation area
of the display with the value of the current control in the data area. The value is also shown and
blink under the "Val" tag on the second row of the display. Use the DATA +/– buttons to change
the value or enter the data by pressing the numerical keys on the keyboard. Press the ENTER key
or the ENTER button to confirm your setting and to save it. When you save your setting, the value
display will stop blinking.
Preset Reset
Press the PRESET key to reset the unit to the factory default setting. "Reset No" will appear in the
Operation area of the display and "No" will blink. Press the DATA+ button (or numerical key 1) to
switch it to "Yes" or DATA– button (or numerical key 0) to switch it to "No. " Press the ENTER key or
the ENTER button to confirm your selection. When "Yes" is confirmed, "Reset" will appear in the
Status Indicator area in the right side of the screen and "Loading..." will appear in the Operation
area of the display. After the reset is complete, the display will show "Reset OK".
19