Connecting The Speaker Cords - Pioneer A-307R Operating Instructions Manual

CONNECTING THE SPEAKER CORDS

1. Strip off the vinyl covering and twist the tip of the
wire core.
10mm
Twist the wire core.
2. Loosen the knob and insert the wire core into the
terminal hole.
3. Tighten the knob to fix the wire core in place.
2
\
1
NOTE:
Do not allow any of the cord conductors to protrude from the
terminals or touch any other conductors. Malfunctioning or
breakdowns may occur when conductors come into contact
with each other.
Speaker Impedance
When speaker systems are connected to only SPEAKERS A
or SPEAKERS B terminals, such speakers should have rated
impedance in the range of 4–16 Ω.
When speaker are connected to both A and B terminals, they
should have a rated impedance in the range of 8 –32 Ω.
CONNECTING THE INPUT/OUTPUT
CORDS
Connect the white plug to the L (left) channel, and the red plug
to the R (right) channel. Be sure to push the plugs securely.
White plug
3
REMOTE CONTROL CORD
CONNECTIONS
By interconnecting the CONTROL jacks of Pioneer units with
the Î mark, the entire system can be operated with this
remote control unit, although some of the units (AM/FM
tuner, CD player, cassette deck, etc.) may not be equipped
with remote sensors. The entire system can be operated by
a remote control unit by connecting PIONEER stereo
components to each other using the control input (CONTROL
IN) jack on each component. Use the remote control cord
supplied with the respective unit for the connection. An
example is shown in the figure. As long as you connect
"OUT" to "IN", the connecting sequence is arbitrary. When
a unit has only an "IN" connector, however, connect it last.
NOTE:
When the POWER switch is set to OFF, the components
connected to the CONTROL OUT jack can not be operated
with the remote control unit.
AM/FM
tuner
CONTROL
OUT
Left channel
L
R
Red plug
control unit
Cassette
CD player
deck
CONTROL
CONTROL
IN OUT IN
OUT IN
CONNECTIONS
Right channel
Remote
A-307R
CONTROL
OUT
5