General Warnings - FLOWMAX Technologies FLOWMAX-90 User Manual

WATER HEATER OPERATING INSTRUCTIONS
Make sure that the authorized technician who tested the water heater has stamped the guarantee booklet.
The installation, first start-up, regulation and maintenance operations must be carried out exclusively by qualified
personnel (e.g. FLOWMAX authorized Service Centres). Incorrect installation can cause damage to property and
injury to persons or animals, for which the manufacturer will not be held responsible.
During the installation, the technician must carry out the following checks:
■ The data on the data plate must correspond to that of the mains supply networks (gas, electricity, water).
■ The water heater must be regulated according to its designed use and performance.
■ The exhaust vent and combustion air intake system must be correctly installed and operational.
■ The exhaust gas discharge and ventilation systems must comply with the requirements of national and local
standards.

General warnings

If there is any doubt as to whether the appliance has been tested by an authorized technician, do not attempt
to start it. All maintenance and gas conversion operations MUST BE CARRIED OUT BY PROFESSIONALLY
QUALIFIED PERSONNEL, registered in accordance with current legislation.
Make sure that the requirements relating to the air intake and ventilation of the room in which the
water heater is to be installed have been complied with.
The water heater is fitted with an antifreeze system. If the water heater is installed in a location where there is
a risk of freezing, the anti-freeze system will only come into operation if the power is on and the gas supply
valve is open (the frost protection is active even with the ON/OFF switch in OFF position). The manufacturer
will not be held responsible for damage to the water heater caused by non-compliance with this instruction.
Should any part of the water heater freeze-up, do not attempt to light it under any circumstances, but instead
call the Service Centre immediately.
The appliance's combustion system must be checked annually. This check includes testing the efficiency of
the water heater and must be carried out by authorized personnel possessing the qualifications as required by
current law.
If the unit fails to re-start after any fault, unplug the unit for 30 seconds, then re-plug in the unit and try to restart with the on/off
switch. If the unit fails to restart, call a qualified Technician for service.
USER INSTRUCTIONS
1