Table of Contents
Advertisement
Pin 1
Pin 2
Pin 3
Pin 4
Pin 5
Pin 6
Pin 7
Pin 8
Pin 9
Pin 10
The "Camera A" outputs are electrically the same as the XLR outputs on the right
side of the mixer. The "Camera B" outputs are electronically isolated from the
"Camera A" outputs. Both outputs can be independently switched to the mic or
line levels.
PSC manufactures a selection of standard AlphaMix Beta snake cables for use
with the new AlphaMix. These cables are available in standard and camera
breakaway versions from any authorized PSC dealer.
follows:
FPSC1091M4A
FPSC1091M4B
FPSC1091M4C
FPSC1091M4D
B:
TO RDAT RECORDERS:
The AlphaMix can be interfaced to virtually any professional recorder via the
standard XLR outputs.
connectors if you desire to use the tape return functions.
C:
TO WIRELESS MICROPHONES:
The AlphaMix will easily accept the output signal from virtually any wireless
receiver. It can accept microphone or line level signal via a simple switch setting.
Please note that most wireless receivers are not compatible with 48PH mic
power.
You should always set the AlphaMix's mic powering switch to "D"
dynamic when using wireless receivers.
The AlphaMix can also be used to send audio signals to Betacams via wireless
transmitters. The use of transmitters is normally accomplished by connecting the
AlphaMix's output XLR to the audio input of the specific transmitter.
transmitter manufacturers supply application specific cables for this purpose.
The AlphaMix has been designed to minimize RF interference through the use of
output transformers and other RF filtering. It is important to note that transmitter
placement greatly affects transmit range and clarity.
transmitters should be mounted away from the mixers surface allowing un-
impeaded RF radiation. This can be accomplished by mounting the transmitters
up and away from the mixer on the PortaBrace Strap.
Left Output High
Left Output Low
Right Output High
Right Output Low
Right Tape Return
Tape Ground
Left Tape Return
Tape Ground
Ground
Ground
15' (4.5M)
15' (4.5M)
25' (7.5M)
25' (7.5M)
In addition, you can use the two 10 pin Hirose tm
14
Part numbers are as
Standard
Breakaway
Standard
Breakaway
For best results,
Many
Advertisement
Table of Contents
