Settings For The Speakers - Sony DAV-TZ215 Operating Instructions Manual

When you select [OTHERS t], select and
enter a standard code from "Parental
Control Area Code List" (page 69) using
the number buttons.
4
Press X/x to select [LEVEL], then press
.
5
Press X/x to select the desired level,
then press .
The lower the value, the stricter the
limitation.
To turn off the [PARENTAL CONTROL]
function
Set [LEVEL] to [OFF] in Step 5.
To play a disc for which [PARENTAL
CONTROL] is set
When you load the disc and press N, the
display for entering your password appears.
Enter your 4-digit password using the number
buttons, then press .
Tip
• If you forget your password, enter "199703" using
the number buttons, then press
ask you to enter a new 4-digit password. After you
enter a new 4-digit password, replace the disc in the
unit and press N. When the display for entering your
password appears, enter your new password.
Changing the password
1
Enter your 4-digit password using the
number buttons, then press
2
Press X/x to select [CHANGE
PASSWORD t], then press
3
Enter a new 4-digit password using the
number buttons, then press
If you make a mistake entering your
password, press C before you press
then input the correct number.
4
To confirm your password, re-enter it
using the number buttons, then press
.
x [MULTI-DISC RESUME]
This system recalls the point where you stopped
the disc the last time it was played and resumes
playback from that point the next time you insert
the same disc.
[ON]: The system stores the resume points in
memory for up to 10 discs.
[OFF]: The system does not store the resume
points in memory. Playback restarts at the
resume point only for the current disc in the unit.
Note
• When the resume playback memory is full, the
x [RESET]
You can return the [SETUP] settings other than
[PARENTAL CONTROL] to the default
settings.
Press C/c to select [YES], then press
You can also quit the process and return to the
Control Menu by selecting [NO] here.
Do not press [/1 while resetting the system as
it takes a few seconds to complete.
Note
• The [MEDIA], [INTERVAL], [EFFECT], and
. The display will
You can adjust the speaker settings manually
without performing the Quick Setup.
.
Select the speakers you will use, set the speaker
distance from your listening position, and then
.
adjust the sound level for each speaker. You can
adjust the sound level by using the [TEST
TONE] function.
.
x [CONNECTION]
,
[FRONT]
[YES]
[CENTER]
[YES]: Normally select this.
[NONE]: Select this if no center speaker is used.
[SURROUND]
[YES]: Normally select this.
[NONE]: Select this if no surround speakers are
used.
resume playback point for the earliest disc is deleted.
[MULTI/2CH] settings also return to the default
settings.

Settings for the speakers

[SPEAKER SETUP]
.
57
GB