Table of Contents
Advertisement
Quick Links
Installer: Leave this manual with the appli-
ance.
Consumer: Retain this manual for future refer-
ence.
WARNING: If not installed, operated and
maintained in accordance with the manu-
facturer's instructions, this product could
expose you to substances in fuel or from
fuel combustion which can cause death or
serious illness.
12427-5-0806
INSTALLATION INSTRUCTIONS
OWNER'S MANUAL
AND
FAN TYPE
VENTED
WALL FURNACE
MODEL
FAW-40-1SPP
FAW-40-1IP
EFFECTIVE DATE
AUGUST 2006
WARNING: If the information in these in-
structions are not followed exactly, a fire or
explosion may result causing property dam-
age, personal injury or loss of life.
— Do not store or use gasoline or other flam-
mable vapors and liquids in the vicinity of
this or any other appliance.
— WHAT TO DO IF YOU SMELL GAS
•
Do not try to light any appliance.
•
Do not touch any electrical switch; do not
use any phone in your building.
•
Immediately call your gas supplier from
a neighbor's phone. Follow the gas sup-
plier's instructions.
•
If you cannot reach your gas supplier, call
the fire department.
— Installation and service must be performed
by a qualified installer, service agency or the
gas supplier.
Page 1
Advertisement
Table of Contents
Related Manuals for Empire AW-40-1SPP
Summary of Contents for Empire AW-40-1SPP
-
Page 1: Installation Instructions
INSTALLATION INSTRUCTIONS OWNER'S MANUAL FAN TYPE VENTED WALL FURNACE MODEL FAW-40-1SPP FAW-40-1IP EFFECTIVE DATE AUGUST 2006 WARNING: If the information in these in- structions are not followed exactly, a fire or explosion may result causing property dam- age, personal injury or loss of life. —... - Page 2 Introduction The base referred to above does not mean the fire-proof base as used Always consult your local Building Department regarding regulations, on wood stoves. The protection is for rugs that are extremely thick and codes or ordinances which apply to the installation of a vented wall light colored tile.
- Page 3 SAFETY INFORMATION FOR USERS OF LP-GAS by point with the members of your household. Someday Propane (LP-Gas) is a flammable gas which can cause fires when there may not be a minute to lose, everyone's safety and explosions. In its natural state, propane is odorless and will depend on knowing exactly what to do.
- Page 4 Ventilation and Combustion Air WARNING: Danger of property damage, bodily injury or death, this furnace and any other fuel burning appliance must be provided with enough fresh air for proper combustion and ventilation of flue gases. Most homes will require that outside air be supplied. opening furnace Do not draw air from a corrosive environment such as a workshop...
- Page 5 C. 4" (102mm) Oval In-The-Wall (all parts purchase locally) Qualified Installing Agency 1. Type B-1 oval pipe or B-W vent pipe Installation and replacement of gas piping, gas utilization equipment or 2. Type B-1 oval elbows or B-W oval elbows accessories and repair and servicing of equipment shall be performed 3.
- Page 6 and attach side wall plate to furnace side of wall with (2) #10 x 1 1/2" (38mm) provided screws. 5. Attach outer boot to the cabinet side with (4) #8 x 1/4" (6mm) provided screws. 6. Position and attach inner boot to inner shield with (4) #8 x 1/4" (6mm) provided screws.
- Page 7 (914mm) plug assembly. Insert 7/8" (22mm) strain relief bushing into #8 x 3/8" (9mm) screws provided. the 7/8" (22mm) hole in the side panel. 8. Align clearance holes on 6" x 10" (152mm x 254mm) duct with Attention! The 7/8" (22mm) strain relief bushing is located within the same screw holes on inner casing back and mark duct to be 2 1/4"...
- Page 8 from the burner box, remove each main burner. Pilot mounting bracket Attention! If one of the above procedures results in pressures in excess will need to be unscrewed and moved out of the way to remove all burners. of 1/2 psig (14" w.c.) (3.5 kPa) on the appliance gas valve, it will result Burners can be blown out using compressed air or by blowing through in a hazardous condition.
- Page 9 Oiling the Motor To reset the manual reset vent safety switch: The fan motor should be cleaned and oiled once each heating season. Oil 1. Remove front panel. holes are located on the top at each end of the motor. Use a few drops of 2.
- Page 10 3. Replace the cover screw after the adjustment to prevent gas leak- 4. Type of gas being used and that shown on the rating label. age. The Service Department at Empire Comfort Systems, Inc. may be contacted P RES S URE REGULATOR� to assist in servicing furnace.
-
Page 11: For Your Safety Read Before Lighting
STANDING PILOT MODEL FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. A. This appliance has a pilot which must be lighted by •... -
Page 12: For Your Safety Read Before Operating
INTERMITTENT PILOT (IP) MODEL FOR YOUR SAFETY READ BEFORE OPERATING WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. A. This appliance is equipped with an ignition device which •... -
Page 13: Sequence Of Operation
SEQUENCE OF OPERATION Apply 24 VAC START To Appliance Thermostat Calls for Heat 5 Minute Retry Delay Pilot Valve Ignition OFF Flame Signal Wait for Flame Signal to Detected Disappear System Check Internal Check Trial for Pilot Valve Opens ... - Page 14 START IP SYSTEM TROUBLESHOOTING SEQUENCE Turn OFF Gas Supply INSET A End View Disconnect System Control SmartValve System Troubleshooting Sequence of Control Harness Note: Before Troubleshooting, Become Familiar Harness 24 Volt Connector Set Thermostat to Call for with the Sequence of Operation Thermostat Heat...
- Page 15 Do not order bolts, screws, washers or nuts. They are standard hardware items and can be purchased at any local hardware store. Shipments contingent upon strikes, fires and all causes beyond our control. Empire Comfort Systems, Inc. Nine Eighteen Freeburg Ave. Belleville, Illinois 62222-0529...
- Page 16 Page 16 12427-5-0806...
-
Page 17: Service Notes
Service Notes Page 17 12427-5-0806... - Page 18 PH: 1-618-233-7420 PH: 1-800-851-3153 FAX: 1-618-233-7097 Empire Comfort Systems, Inc. FAX: 1-800-443-8648 Nine Eighteen Freeburg Ave. E-MAIL: info@empirecomfort.com Belleville, Illinois 62220-2623 WEB SITE: www.empirecomfort.com Page 18 12427-5-0806...