Yanmar 2YM15 Operation Manual page 70

PERIODIC MAINTENANCE
1. Check that the control lever on the
engine side moves to the high-speed
stop position and low-speed stop
position when the remote control lever
is moved to H (high speed) and L (low
speed) respectively.
2. When there is deviation, loosen the
bracket for the remote control cable on
the engine side and adjust.
3. Adjust the high-speed stop position first
and then adjust the low-speed idling
using the adjustment bolt on the remote
control lever.
Adjusting Clutch Remote Control Cable
Figure 4
4
Figure 5
1 – Marine Gear
2 – Control Cable
3 – Control Lever
4 – Bracket (cable)
1. Check that the control lever
(Figure 5, (3)) moves to the correct
position when the remote control cable
handle is moved to the NEUTRAL,
FORWARD and REVERSE positions.
2. Use the NEUTRAL position as the
standard for adjustment. When there is
deviation, loosen the bracket
(Figure 5, (4)) for the remote control
cable on the clutch side and adjust.
64
Adjusting Propeller Shaft Alignment
The flexible engine mounts are
compressed slightly during initial engine
operation and may cause misalignment
between the engine and the propeller
shaft.
After the first 50 hours of operation, the
alignment should be checked and
readjusted if necessary. This is considered
normal maintenance and the adjustment
requires specialized knowledge and
techniques. Consult your authorized
Yanmar Marine dealer or distributor.
2
1
3
0004799
YM Series Operation Manual