Dodge Grand Caravan 2012 User Manual page 76

ELECTRONICS
• Erase all channels before you begin programming. To erase the channels, place the
ignition switch into the ON/RUN position, then press and hold the two outside
HomeLink ® buttons (I and III) for up 20 seconds or until the red indicator flashes.
NOTE:
• Erasing all channels should only be performed when programming HomeLink
first time. Do not erase channels when programming additional buttons.
• If you have any problems, or require assistance, please call toll-free 1–800–355–
3515 or, on the Internet at www.HomeLink.com for information or assistance.
Programming A Rolling Code
• For programming Garage Door Openers that were manufactured after 1995. These
Garage Door Openers can be identified by the "LEARN" or "TRAIN" button located
where the hanging antenna is attached to the Garage Door Opener. It is NOT the
button that is normally used to open and close the door. The name and color of the
button may vary by manufacturer.
• Place the ignition switch into the ON/RUN position.
• Place the hand-held transmitter 1 to 3 inches (3 to 8 cm) away from the
HomeLink ® button you wish to program while keeping the HomeLink
light in view.
• Simultaneously press and hold both the HomeLink
and the hand-held transmitter button.
• Continue to hold both buttons and observe the indicator light. The Homelink
indicator will flash slowly and then rapidly after Homelink
frequency signal from the hand-held transmitter. Release both buttons after the
indicator light changes from slow to rapid.
• At the garage door opener motor (in the garage), locate the "LEARN" or
"TRAINING" button. This can usually be found where the hanging antenna wire is
attached to the garage door opener motor. Firmly press and release the "LEARN"
or "TRAINING" button.
NOTE: You have 30 seconds in which to initiate the next step after the LEARN button
has been pressed.
• Return to the vehicle and press the programmed HomeLink
the button for two seconds each time). If the device is plugged in and activates,
programming is complete.
74
Before You Begin Programming HomeLink®
• Be sure that your vehicle is parked
outside of the garage before you begin
programming.
• For more efficient programming and
accurate transmission of the
radio-frequency signal it is
recommended that a new battery be
placed in the hand-held transmitter of
the device that is being programmed to
the HomeLink ®
button you want to program
®
®
system.
® for the
® indicator
®
has received the
button twice (holding
®