System Menu - Flanders Scientific LM-0750W User Manual

System Menu

System Menu Organization
Main Menu
Function DVI Selection
Scopes & VU-Meters DVI Pixel Format
Video Component Input
Audio Component Pixel Format
Marker 3G Level B
System Back Light
Alarm Back Light Interval
OSD LED Light
GPI Zoom
Display Alignment Language
System Status Part Display
Support Load Profile
Save Profile
System Menu Functions

DVI Selection / DVI Pixel Format
FSI Monitors are equipped with a DVI-I Input, which supports both DVI Digital and DVI Analog sources. To
select between DVI-D (Digital) and DVI-A (Analog) simply toggle this control accordingly. Use DVI Pixel for-
mat to select between Full RGB (0-255), Limited RGB (16-235), or YCbCr modes.

Component Input / Component Pixel Format
Use Component Input to toggle between Component & Composite Video on LM-0750W's shared analog in-
puts. Use Component Pixel Format to toggle the Analog Component Video Inputs between YPbPr or RGB
mode.

3G Level B
When monitoring a 3Gbps
SDI Level B signal (monitor
must be equipped with 3Gbps
SDI Inputs) compromised of
two distinct 1.5Gbps HD-SDI
signals that have
muxed together you can use
this 3G Level B selection to
select different monitoring
options including: Stream 1,
Stream 2, PAP, PIP, POP,
Vertical Split, Horizontal Split,
Overlay Mode. Please note
that Level B 3Gbps SDI re-
quires that both 1.5Gbps sig-
nals share the same frame
rate and resolution and that
Link A and Link B are
genlocked. For signals using
SMPTE 425M-B image for-
mat mapping to transport SMPTE 372M formatted Dual Link information (4:4:4 YCbCr or RGB / 1080p50/60)
the Overlay Mode should be used to view the combined LinkA and LinkB data as a single video signal.
System
been
DVI-D
Full RGB
COMPONENT
YPbPr
Stream 1
35
On
On
Keypad
English
Off
Default
Profile 1
21
Back to Table of Contents
© 2011 Flanders Scientific, Inc.