Samsung SPE-101 User Manual page 23


J
The default password can be exposed to a hacking thread so it is recommended to change the
password after installing the product.
Note that the security and other related issues caused by the unchanged password shall be
responsible for the user.
6. Click [OK].
Manual network setup will be completed.
If the Broadband router has more than one network video encoder connected
Configure the IP related settings and the Port related settings distinctly with each other.
Category
IP related settings
Port related settings

M
If the <HTTP Port> is set other than 80, you must provide the <Port> number in the address bar
of the Internet browser before you can access the network video encoder.
ex) http://IP address : HTTP Port
http://192.168.1.100:8080
Auto Network Setup
Run <IP Installer_vX.XX.exe> to display the network device search list.
At the initial startup, both [Auto Set] and [Manual Set] will be grayed out.

M
Use the IP Installer in version 1.47 or later.

For network devices found with the IPv6 setting, these buttons will be grayed out as the cameras
do not support this function.
1. Select a network device from the
search result.
Find the MAC (Ethernet) address labeled
on the rear of the network device.
Both the [Auto Set] and [Manual Set]
buttons will be activated.
2. Click [Auto Set].
The Auto Setting dialog appears.
The <IP Address>, <Subnet Mask>, and <Gateway> will be set automatically.
Network video encoder #1 Network video encoder #2
IP Address 192.168.1.100
Subnet Mask 255.255.255.0
Gateway 192.168.1.1
HTTP Port 8080
VNP Port 4520
192.168.1.101
255.255.255.0
192.168.1.1
8081
4521
English _23