Ethernet Connection; Power Supply - Samsung SPE-101 User Manual

Ethernet Connection

Connect the Ethernet cable to the local network or to the Internet.

Power Supply

Use the screwdriver to connect each line (+, –) of the power cable to the corresponding
power port of the network video encoder.

J
Be careful not to reverse the polarity when you connect the power cable.
You can also use a router featuring PoE (Power over Ethernet) to supply power to the device.

If PoE and DC 12V are both applied, this device will get supplied with power from PoE.

If you want to connect an external device, you must turn off the external device before proceeding.
Electrical Resistance of Copper Wire at [20°C (68°F)]
Copper Wire Gauge (AWG)
Resistance (Ω/m)
Drop Voltage (V/m)
Recommended Distance (m)

As shown in the table above, you may encounter a voltage-sag depending on the wire length.
If you use an excessively long wire for network video encoder connection, the network video encoder may
not work properly.
- Network Video Encoder Operating Voltage : DC 12V±10%
- Voltage drop measurements on the chart above may vary depending on the type and manufacture of
the copper cable.
LINK
- +
DC 12V
NETWORK / PoE
SPE-101
Video Encoder
Power
#24(0.22mm ) #22(0.33mm
2
0.078
0.028
Less than 20
ACT
Ethernet
) #20(0.52mm
2
0.050 0.030
0.018 0.011
Less than 30 Less than 30
) #18(0.83mm )
2 2
0.018
0.006
Less than 30
English _15