Advertisement
Programming
Setting the time and day
1.
Turn the mode selector switch to the
2.
Press the '+' and '-' buttons to set the day
3.
Press and hold the '+' or '-' button to cycle through the time faster.
4.
Cycle through the time until the correct number corresponds with the present day (see Table 3)
(i.e. If the present day is Tuesday, cycle through the time until the number 3 starts to flash at the
top of the screen)
5.
Once the present day is found set the time using the '+' and '-' buttons
Setting the daily program
1.
Turn the mode selector switch to the 'PROG' position.
2.
'P=1' will be displayed. for zone 1 to be programmed.
(To program another zone, press the '+' button and 'P=2' will be displayed for zone 2)
3.
Press 'OK' and 'P=' will be displayed with the number '1' at the top of the screen to signify the first day.
4.
Press the '+' button for one hour of 'comfort' or 'on' and press the '-' button for one hour of 'background', 'off' or
'frost protection' (depending on the configuration chosen).
5.
If you wish to repeat a program for the following day, hold down the 'OK' button for 5 seconds and the
controller will automatically copy the current program over to the next day
6.
Press 'OK' to confirm
7.
'2' will now appear at the top of the screen to signify the second day. Repeat steps 4 and 5 until all seven days are programmed
9.
After programming zone 1, 'P=1' will be displayed again. Now press the '+' button to programme zone 2, 'P=2' will be displayed.
10.
Press 'OK' and repeat steps 2-4
11.
To run the program, set the mode selector switch to the 'AUTO' position
Configuration– Heater Modes
IMPORTANT - The ON/OFF mode (C1=2) cannot be used in conjunction with DuoHeat radiators.
The controller can be configured to operate various heater modes, dependant
on the heating requirement. (As shown in Table 3)
1.
To change the configuration, turn the dial to the
2.
The display will change to 'PARA'
3.
Press and hold down the '+' and '-' buttons and C1=1 will be displayed
4.
To change the setting to 'C1=2' or 'C1=3', press the '+' or '-' buttons
and press 'OK' to confirm (display returns to 'PARA')
5.
If you wish to change these settings in the future turn the mode selector
switch to the
position and repeat steps 2-4.
Note: The configuration chosen will apply to all zones.
position.
Fig.8
position
Fig.9
Fig.7
Display
Mode
C1=1
Comfort and background
C1=2
On and Off
C1=3
Comfort and frost protection
Number
Day
1
Sunday
2
Monday
3
Tuesday
4
Wednesday
5
Thursday
6
Friday
7
Saturday
Table 3
Fig.8
Table 4
Hide quick links:
Advertisement
