Operation - Yard Works YW1100TP Instruction Manual

OPERATION

Turning the Pump On and Off
Note: When the pump is fully primed and air is flushed out of the suction cycle,
the pump is ready to operate. The pump may take several minutes to fully prime air
from the suction line and inside the pump.
1. Turn the pump on at the mains power.
2. Depress the ON/OFF switch (8) to the "l" position (Fig. 9).
Fig. 9
3. To turn the pump off, depress the ON/OFF switch (8) to the "0" position.
Storing the Pump
Before storing the pump, it is recommended to empty the pump body of any water.
Turn the drain screw (6) anti-clockwise and remove from the pump body (Fig. 10).
This will drain any excess water. Replace the drain screw (6).
Note: Ensure the gate valve on your water tank is not left open as this will allow
water to drain from the tank.
Fig. 10
12